Channel2EFXloop
CH2EFX-Send
This jack is located on the back panel. The signal is sent dry, with no equalization.
CH2EFX-Return
This jack is located at the back of the unit. When a signal is fed back into the CH2 EFX-RTN jack
it can go directly into the amps or it can be combined with the internal digital effects depending on
whether the Channel 2 EFX switch is in or out.
Do not use both the phone and XLR inputs at the same time,
signals will be highly attenuated!!
EffectsLevelControl(dry/wet)
This control is used to increase or decrease the amount of internal effects used to enhance the
sound from an input source on either Channel 1 and 2. The effects level control can be bypassed
via a foot switch.
MasterVolume
The master control is used to increase or decrease the oAvMe1r0a0l.l oIut tphuats onfo tehfef ect
on the line out signal level or the Channel 2 effects loop.
LineOut
The line out is post channel 1 and 2 but pre-effects, which means the gain controls and Channel
1ms equalization do affect the output to the balanced line out, but the master volume control does
not. No effects are sent through this output unless used prior to the amplifier (eg. If you have your
guitar plugged directly into an effect, then AM1plugged 00 ). You into can the use this output to
directly connect to a mixer, or another amplifier.
Tips
t If the line out is used to inject a signal into a mixer and no output power is desired from the
AM100 speakers, set the master control to o0p and increase or decrease the gain control on
either or both of the channels.
t Clip LED on Channel The 1:clip LED will illuminate if the input gain and/or the signal at the
EQ section is too hot. This will drive the amp to clipping. Adjust the - Volume control or EQ con
trols on channel 1 accordingly.
t Clip LED on ChanneTlh e2 :c lip LED will illuminate if the input gain is high enough to clip
the amplifier output. Adjust the Volume control on channel 2 accordingly.
DigitalEffects
There are 32-digital effects presets altogether in Banks A and B, with 16-presets for each. Bank A and
Bank B are switchable via a bank select switch on the front panel of the amp. When the switch is in
the In position, an amber LED is turned on indicating Bank A is enabled. In the Out position, Bank B is
enabled and the light goes out. This feature can also be accessed using an optional footswitch.
DigitalEffectsBankA/B
The AM100 has 2 banks consisting of 16-presets for each. The numeric selection of each preset
and its description is located on the front panel. An Effects Table with brief descriptions for the
presets is located near the end of the Ownerms Manual.
Footswitch
Connect a standard footswitch here to turn the internal effects system -on or off. It does not regu
late the external effects loop.
2 |
ACEC
