Maintenance
1. Bodywork3. Cleaning of the drainage area
Clean the outside of the machine with warm waterThe drainage area must be cleaned if the pump has
and a neutral, non-abrasive household detergent.been blocked with objects such as buttons, safety
Rinse with clean water and dry with a soft cloth.pins, coins, etc. , or if lint has built up because
Important: do not use methylated spirits, solvents orclothes that generate lint have been washed at high
temperatures.
similar products to clean the bodywork.
Y Pull out the plug from the power socket.
2. Detergent dispenser drawerY If necessary, wait until the water has cooled down.
Y Open the drainage area door.
After a while, detergents and fabric softeners leaveY Place a bowl to collect the water.
deposits in the drawer.Y Release the emergency emptying hose, place it in
Clean the drawer from time to time by rinsing it underthe bowl and remove its cap, when the bowl is full
a running tap. To remove the drawer from theput the cap back on the emergency emptying hose.
machine, press the button in the rear left-handY Empty the bowl. Repeat the procedure until you
corner.
have completely emptied the washing machine.
To facilitate cleaning, the top part of the additive
compartments can be removed.
P1114P1115
R0072C0073
Detergent can also accumulate inside the drawerY To continue, unscrew the lid of the diaphragm by
recess: clean it with an old toothbrush. Refit theturning it counter clockwise and pull it out.
Y Remove the objects such as buttons, coins and the
drawer after cleaning.lint that has been accumulated in the area of the
pump impeller by rotating it.
Y Screw the lid of the diaphragm clockwise, be sure
is completely tighten.
Y Replace the emergency emptying hose in its initial
position and close the drainage area door.
P1116P1117
18 |
ACEC
