Cool Check Guide
INSTALLATION
The guide consists of a temperature sensitive strip
Importantsealed in a shelf trim.
Important
When the fridge is operating at the safe temperature
IF YOU ARE DISCARDING AN OLD APPLIANCE THATto store food the guide will appear black. If the
It must be possible to disconnect the appliance from
HAS A LOCK OR CATCH ON THE DOOR, YOU MUSTtemperature rises above this level the guide will
the mains power supply; the plug must therefore be
ENSURE THAT IT IS MADE UNUSABLE TO PREVENTshow the words TOO WARM.
easily accessible after installation.
TOO WARM
YOUNG CHILDREN BEING TRAPPED INSIDE.
Depending upon the position which you choose for yourPositioning of the Cool Check
appliance, you may wish to reverse the way in which
The shelf with the cool check temperature guide
the door opens. To do this, refer to instructions on ?Door
must be placed in the fridge according to the
reversal?.
instructions located on the fridge wall and always
Please ensure that when the appliance is installed it
ensure the guide is at the front.
is easily accessible for the engineer in the event of
a breakdown.
If the Cool Check shows TOO WARM
PositioningIn certain conditions the temperature guide may
This appliance should only be installed at a locationshow TOO WARM if:
where the ambient temperature corresponds to the? The fridge is switched off
climate classification indicated on the rating plate, which
? The door has been recently openedZANUSSI
is located at the left on the inside of the appliance.
? A quantity of warmer food has been introduced to
The following table shows which ambient temperature is
the fridge
correct for each climate classification:
CCOO2
? The fridge temperature is above the
SN +10°C to + 32°C
recommended maximum for the safe storage of
food.
N +16°C to + 32°C
100 mm
The cool check will change to show ?TOO WARM?
ST +18°C to + 38°C
ABvery quickly after the door has been opened. It will
T+18°C to + 43°Chowever take a number of hours to return to black,
It should be located in a dry atmosphere, out of directindicating that the temperature is correct.
sunlight and away from extreme temperature e.g. not10 mm10 mmThe appliance should be left overnight and the cool
next to a boiler or radiator, or in a very cold room e.g. anNP007check examined in the morning. If the cool check
outhouse, where the temperatures may fall below 10°Cshows TOO WARM, turn the thermostat to a colder
(50°F). If these temperatures are exceeded i.e. colder orsetting leave overnight and examine again the
warmer, then the appliance may not operate correctly.following morning.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There must
also be at least 100 mm (4?) distance between the top ofHints and Tips
the cabinet and any overhanging kitchen furniture (A).
? The guide is only suitable for use in the model
Ideally, the appliance should not be positioned beneath
supplied.
overhanging furniture (B).
There should also be a gap of 25 mm either side of the? The guide will not operate in a freezer
appliance. Do not obstruct the space underneath. Thecompartment.
back of the cabinet may be placed close to the wall but? When cleaning the shelf take care not to immerse
must not touch it. DO NOT install in places within water, and wipe away any spills.D200
restricted ventilation.
Adjust the level of the appliance by screwing out the
adjustable foot, or feet, at the bottom of the cabinet
using your fingers.
Rear spacers
The plastic bag containing all relevant
documentation also contains two spacers to be fitted
into special holes in the back of the appliance.
A
Fit the spacers into the holes, taking care to ensure
that the arrow (A) is positioned as shown in the45°
diagram. Then turn them through 45° (arrow (A)PR60
vertical) until they lock into place.
7
14 |
ACEC
