Before use
Adjustment on the machine
Before using your dishwasher for the
AB
first time:
1.Ensure that the electrical and water connections comply
with the installation instructionsA
1 2
2.Remove all packaging from inside the appliance
3.Set the water softener
4.Pour 1 litre of water inside the salt container and then fill
with salt
5.Fill the rinse aid dispenser.
AA04AA03
Setting the water softener
Filling with salt
The dishwasher is equipped with a water softener designed to
remove minerals and salts from the water supply, which Attention!would
have a detrimental or adverse effect on the operation Only of use thesalt specifically designed for use in
appliance.dishwashers.
All other types of salt not specifically designed for use in
The higher the content of these salts, the harder your water is.
dishwasher, especially table salt, will damage the water
Water hardness is measured in equivalent scales, Clarke,
softener.
French degrees and PPM (parts per Million).
Only fill with salt just before starting a washing
The softener should be adjusted according to the hardness of
programme. This will prevent any grains of salt or salty
the water in your area.Your local Water Authority can advise
water, which may have been spilled, remaining on the
you on the hardness of the water in your area.
bottom of the machine, which may cause corrosion.
The dishwasher is factory set at level 2.
If this level is not suitable for your area the softener should be
To fill:
adjusted.
If your water is level 1 it is already soft and theref1.Toore fill with unscresalt, w the cap of the salt container.
there is no need to use salt.
2.Pour 1 litre of water inside (this the container is necessary
In this case adjust the water softener on level 1 without
only before filling with salt for the first time).
using salt.
3.Using the funnel (if
Only for dishwasher models with salt refillprovided), pour in the salt
until the container is full.SALE
indicator light:SALT
Do not worry if water over SALZ
if the water softener has been adjusted on level 1 without useSEL
flows from the unit when
of salt, the salt refill indicator light on the control panel will
filling with salt, this is quite
always remain illuminated when the machine is switched on.
normal.
To adjust the water softener, follow the instructions given
4.Replace the cap making
in the chart
sure that there is no trace
Water hardnessof salt on the screw thread
SR06
or on the gasket.
Adjustment
FrenchClarkePPMUseWater
Level
degrees degrees (parts perof5.Screw on the cap tightly.softeneron the machine
(°TH)million) saltadjustmentAB
10 - 80 - 80 NONO1The salt container will require topping up periodically.0 - 6-
According to the model, an indicator reminds you when filling
29 - 207 - 1481 - 200YES-NO1
with salt:
321 - 4015 - 28201 - 400YES+NO1
A)The salt cap has a refill
441 - 7029 - 49401 - 700YES-YES2
indicator window in the
571 - 9050 - 63701 - 900YES+YES2centre.
A green float is clearly
visible when there is salt
Water softener adjustmentinside the container, and
almost disappears when
the salt has finished
reminding you to add salt.SR11
B) A salt indicator light on the
control panel will come on
when the salt has finished.
The salt indicator light on the control panel can remain
AA01illuminated for 2-6 hours after the salt has been
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer.
The function of the machine is not affected.
2 |
ACEC
