Water outlet hose connectionElectrical connection
The end of the drain hose can be connected in the followingInformation concerning the electrical connection is given on the
ways: rating plate on the edge of the dishwasherOs door.
1.To the sink outlet spigot, securing it to the underside of the Before plugging the appliance into the wall socket, make sure
work surface. This will prevent waste water from the sink that:
running into the machine.
1.The mains voltage and current rating at the site of
2.Hooked over the edge of the sink using the special curved installation match the nominal voltage and current rating
plastic guide (if provided with the machine). given on the rating plate.
3.To a stand pipe provided with vent-hole, minimum internal 2.The meter, fuses, mains power supply and wall socket can
diameter 4 cm. all take the maximum load required. Make sure that the
socket and plug are compatible without having to use any
The waste connection must be at a height of between 30 cmtype of adaptor. If necessary, have the domestic wiring
(minimum) and 100 cm (maximum) from the bottom of the
dishwasher. system socket replaced.
The drain hose can face either to the right or left of the
To isolate the dishwasher from mains, remove the mains plug.
dishwasher Important!
Ensure the hose is not bent or squashed as this could preventThe plug must still be accessible after the appliance
or slow down the discharge of water.
The sink plug must not be in place when the machine ishas been installed.
draining as this could cause the water to siphon back into theIn case that the electrical cable has to be replaced,
machine. please contact your local consumer services
department.
If you use a drain hose extension it must be no longer than 2The appliance should not be connected to the
metres and its internal diameter must be no smaller than theelectrical supply by means of an extension cable.
diameter of the hose provided.
Safety standards require the appliance to be
earthed.
The manufacture accepts no liability for failure to
observe the above safety precautions.
CS18
Likewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than the
diameter of the hose provided.
Attention!
Our appliances are supplied with a security device to protect
against the return of dirty water back into the machine.
If the spigot of your sink has a "no return valve" incorporated
this can prevent the correct draining of your dishwasher.
We advise you therefore to remove it.
5 |
ACEC
