Using the appliance
Starting the programmePause function
1. Scrape or rinse off solid food remnants.With the pause function the programme can be temporarily
2. Load the dishwasher. interrupted for a short period of time.
(See the basket and loading).1. Press in the On/Off button. The programme stops.
3. Put the correct amount of detergent into the 2. All lamps goes out.
detergent dispenser and close the dispenser lid.
3. When you want the programme to continue again,
4. Close the door.you press the On/Off button.
The programme continues.
5. Press in the On/Off button. The lamp for the
On/Off button comes on.The programme should not be paused for any
longer than necessary, because the water inside
6. Press in the required programme button (see pro-the dishwasher has cooled down and must be
gramme chart). Programme indicator lamp is lit.
During the three seconds the two top indicator heated again which increases the power
lamps are �ashing, you can select another pro-consumption.
gramme cycle. If not, the selected programme Cancelling the drying phase
starts. The lamp indicates which part of the
selected cycle the dishwasher is in. In case you do not want to wait until the drying phase is
7. Check the strainers/Å¢lters to see if they need to completed, you can cancel it.
be cleaned when the dishwasher has Ţnished 1. Press in the On/Off button. The control lamp for
the programme.
the On/Off button goes out.
If both the top and middle indicator lights are2. Open the door. The drying phase is cancelled.
flashing, Ţrst check that the door is properly closed,
if it is read the section �Something Not Working�.
Switching the dishwasher off
Stopping the programme temporarilySwitch the dishwasher off, when the indicator lamp
for the programme cycle end is lit.
1. Open the door. The programme stops.
1. Press in the On/Off button. The control lamp for
2. The programme indicator lamp is lit.the On/Off button goes out.
3. Close the door and the programme continues Be careful if you open the door immediately
after about six seconds. after the programme is Ţnished, since hot steam
may escape.
Open the door carefully when the dishwasher is
running, since hot steam may escape.
This dishwasher has a new feature called
�IMPULSE WASHING�. This washing system
Cancelling the programmevaries both the revolutions of the pump and the
water pressure for more intensive cleaning of the
1. Press and hold in the combination buttons untildishes during the programme. That is why different
the indicator light for the programme goes out.
sections of the programme cycle do not sounds
2. Release the buttons. The programme is now the same.
cancelled and a new programme can be selected.
If you switch the dishwasher off, the selected
programme is not cancelled, it is only interrupted.
When you start the dishwasher again, the pro-
gramme will continue.
- 9 - |
ACEC
