Service
Service and Spare PartsCustomer Care Department
In the event of your appliance requiring service, or if youFor general enquiries concerning your Zanussi appliance
wish to purchase spare parts, please contact your localor for further information on Zanussi products, please
Service Force Centre by telephoning:contact our Customer Care Department by letter or
telephone at the address below or visit our website at
08705 929929 www.zanussi.co.uk
Your telephone call will be automatically routed to theCustomer Care Department
Service Force Centre covering your post code area. Zanussi
55-77 High Street
For the address of your local Service Force Centre and
further information about Service Force, please visit theSlough
website at www.serviceforce.co.ukBerkshire
SL1 1DZ
Before calling out an engineer, please ensure you haveTel:08705 727727 *
read the details under the heading �In the event of a fault�.
When you contact the Service Force Centre you will need* call to this number may be recorded for training purposes.
to give the following details:
1.Your name, address and post code
2.Your telephone number
3.Clear and concise details of the fault
4.The model and serial number of the appliance
(found on the rating plate)
5.The purchase date
Please note that a valid purchase receipt or guarantee
documentation is required for in-guarantee service calls.
Never attempt to repair the dishwasher yourself.
Repairs carried out by unauthorized or inexperienced
persons can cause injury or serious malfunctioning.
Information for test centres
The salt container and rinse aid dispenser shall be Ţlled in accordance with this instruction manual.
Before conducting the measurements the dishwasher shall be operated for one or two complete cycles using
detergent and a clean load.
Test standard:EN 50242 och EN 60704
Rated capacity:6 place settings accordance EN 50242
Loading of basket:accordance Ţgure on page 10
Test program:energy saving 55! C
Detergent (IEC type B):15 gram in the dispenser + 3 gram in the pre-wash dispenser
Rinse aid (type III):setting 3
Feed water pressure:minimum 0,8 bar, maximum 10 bar
- 13 - |
ACEC
