Prior to using for the first time
Before using your dishwasher for the first time:
To select a different level proceed as
1.Ensure that the electrical and water connections comply follows:
with the installation instructions.
(The dishwasher must be switched off)
2.Remove all packaging from inside the appliance.
1. Press function push buttons 1 and 2 simultaneously.
3.Set the water softener.
4.Pour 1 litre of water inside the salt container and then fill
2.While keeping the function push buttons 1 and 2 pressed
with salt.
switch on the dishwasher by pressing the On/Off push
5.Fill the rinse aid dispenser.button.
The On/Off indicator light comes on.
At the same time, the indicator lights of function push
Setting the water softenerbuttons 1 and 2 start flashing.
The dishwasher is equipped with a water softener designed to
3.Press function push button 1, the indicator light of function
remove minerals and salts from the water supply, which would
push button 2 turns off, while the indicator light of function
have a detrimental or adverse effect on the operation of the
push button 1 remains fixed for about 5 seconds, after this it
appliance.
starts flashing indicating the current level of the water
The higher the content of these salts, the harder your water is.
softener.
Water hardness is measured in equivalent scales, Clarke
The current level is indicated by the number of flashes
degrees, French degrees and PPM (parts per Million).
made by the indicator light of function push button 1, that
The softener should be adjusted according to the hardness of
alternates 5 seconds off with a number of flashes, this for
the water in your area. Your local Water Authority can advise
about 60 seconds.
you on the hardness of the water in your area.
Example:
The water softener must be set in both ways: manually, using
1 flash= level 1
the water hardness switch and electronically, using the function
2 flashes = level 2
push buttons on the control panel.
3 flashes = level 3
4 flashes = level 4
Water hardness
5 flashes = level 5
ClarkeFrenchPPMLevel Use of
degreesdegrees(parts persalt4.To change the level, press function push button 1. Each
(!TH)million)time the push button is pressed the level changes.
50 - 6371 - 90701 - 9005yesExamples:
36 - 4951 - 70if the current level is 3, by pressing function push button 1501 - 7004yes
once, level 4 is selected.
yes22 - 3531 - 50301 - 5003
if the current level is 5, by pressing function push button 1
6 - 218 - 3080 - 3002yesonce, level 1 is selected.
< 8The indicator light of function push button 1 remains off for < 6< 801no
about 5 seconds after which it starts flashing indicating the
new level selected.
If your water is level 1 it is already soft and therefore there
5.To memorise the new level, switch off the dishwasher by
is no need to use salt. With the setting of the water
pressing the On/Off push button.
softener at level 1 the salt indicator light on the control
panel will always remain off.
5 |
ACEC
