Filling with saltRinse aid
Only use salt specifically designed for use inRinse aid is automatically added during the last rinse, ensuring
dishwashers.thorough rinsing, and spot and streak free drying.
All other types of salt not specifically designed for use inThe dispenser, which is positioned inside the door, holds about
a dishwasher, especially table salt, will damage the water110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
softener.programmes, depending upon the dosage setting.
Only fill with salt just before starting one of the complete
washing programmes.
This will prevent any grains of salt or salty waterFilling with rinse aid, which
may have been spilt, remaining on the bottom of the
1.Open the container by turning the lid (A) anticlockwise.
machine for any period of time, which may cause
corrosion.2.Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
To fill:
1.Open the door, remove the lower basket and unscrew the
cap of the salt container.
2.Pour 1 litre of water inside the container (this is necessary
only before filling with
salt for the first time).
SALE
3.Using the funnel provided, ZOUT
SALT
pour in the salt until the SALZ
SEL
container is full.
BR01BR13
4.Replace the cap making
sure that there is no trace Ensure that the lid is closed after every refill.
of salt on the screw thread
or on the gasket.
5.Screw on the cap tightly.
SR14
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (C)
The salt container will require topping up periodically. You are
(position 1 minimum dosage, position 6 maximum dosage).
reminded of this by the salt indicator light on the control panel
Increase the dose if there are drops of water or lime spots on
which comes on when the salt has finished.
the dishes after washing.
The salt indicator light on the control panel can remain
Reduce it if there are sticky
illuminated for 2-6 hours after the salt has been
whitish streaks on the dishes.
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer. The function of the machine is not
affected.
Do not worry if water over flows from the unit when filling with
salt, this is quite normal.
BR02
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
6 |
ACEC
