Maintenance and cleaning
Clean the external surfaces of the machine and control panel8. Place the coarse/fine filter (A/B) in the microfilter C) and
with a damp soft cloth. If necessary use only neutralpress together.
detergents. Never use abrasive products, scouring pads or
9. Put the filter combination in place and lock by turning the
solvent (acetone, trichloroethylene etc....).
handle clockwise to the stop. During this process ensure
Ensure that the seals around the door, the detergent and rinsethat the flat filter does not protrude above the base of the
aid dispensers are cleaned regularly with a damp cloth.washing compartment.
We recommend the use of Finish Dishwasher Cleanerevery
Under no circumstances may the dishwasher be used
3 months or run a 65!C wash programme without dishes using
without filters.
detergent.
Incorrect repositioning and fitting of the filters will
Regular use of Finish Dishwasher Cleanercleans
produce poor washing results.
inaccessible parts, eliminates unpleasant food odours and
helps prevent the build-up of limescale.
NEVER try to remove the
upper spray arm.
Cleaning the filters
If residues of soil have
The filters in the base of the washing compartment are to a
clogged the holes in the
large extent self-cleaning. Nevertheless the filters should be
upper spray arm, remove
checked and cleaned from time to time. Dirty filters will
them with a toothpick.
degrade the washing result.
1. Open the door, remove the lower basket.
2.The dishwasher filter system comprises a coarse/fine filter
MA33
(A/B), a microfilter (C) and a flat filter (D).
Some dishwasher will only have a coarse filter (A), a
microfilter (C) and a flat filter (D).Check that the WRD is not clogged with detergent residue. If
Unlock the filter system using the handle on the microfilternecessary rinse it under running water after having removed it,
and remove.from the basket by twisting it
anticlockwise and pulling it
upwards.
Never use your dishwasher
without the WRD dispenser.
Since WRD also ensures
correct distribution of the
water to the upper spray
arm, running the
dishwasher without it will
impair the washing results.MA11
MA35
MA32
1
3. Turn the handle about /4 a turn anticlockwise and remove.
Prolonged periods of non-operation
If you are not using the machine for any period of time you are
advised to:
1.Unplug the appliance and then turn off the water.
2.Fill the rinse aid dispenser.
3.Leave the door ajar to prevent the formation of any
unpleasant smells.
MA36
4.Leave the inside of the machine clean.
4. Take hold of the coarse/fine filter (A/B) by the handle with
the hole and remove from the microfilter (C).
Frost precautions
5. Clean all filters thoroughly under running water.
Avoid placing the machine in a location where the temperature
6. Remove the flat filter (D) from the base of the washing
is below 0!C. If this is unavoidable, empty the machine, close
compartment and clean both faces thoroughly.
the appliance door, disconnect the water inlet pipe and empty
it.
Moving the machine
If you have to move the machine (moving house etc....):
1. Unplug it.
MA31
2.Turn the water tap off.
3.Remove the water inlet and discharge hoses.
7. Put the flat filter (D) back in the base of the washing
4.Pull the machine out together with the hoses.
compartment.
Avoid over tilting the machine during transportation.
14 |
ACEC
