Cutlery should be placed in the removable cutlery basket withAdjusting the height of the upper basket
the handles facing downwards. If the handles protrude from
the bottom of the basket, obstructing the lower spray arm, loadIf washing very large plates you can load them in the lower
the cutlery with the handles facing upwards.basket after moving the upper basket to the higher position.
Mix spoons with other cutlery to prevent them from stickingMaximum height of the dishes in
together.
For best results weupper basketlower basket
recommend you to use theWith upper basket raised20 cm31 cm
cutlery grids provided (if the
size and dimensions of theWith upper basket lowered24 cm27 cm
cutlery allow it).
To move to the higher position proceed as
The cutlery basket is in twofollows:
parts which can be
separated to give greater1.Pull out the basket until it stops.
loading flexibility. To separate2.Carefully lift both sides upwards until the mechanism is UI63
the two parts, slide themengaged and the basket is stable.
horizontally in opposite
directions and pull them
apart. Attention!
To reassemble, reverse theNever lift or lower the
procedure.basket on one side only
When the basket is in the
higher position you will not
be able to use the cup
UI62rack(s).
RC08
The upper basket
The upper basket is designed for plates (dessert plates,To lower the basket to the original position
saucers, dinner plates of up to 24 cm in diameter), salad
proceed as follows:
bowls, cups and glasses. 1.Pull out the basket until it stops.
Arrange items on and
underneath the cup racks so2.Carefully lift both sides upwards and then allow the
that water can reach allmechanism to drop back down slowly, keeping hold of it.
surfaces.
Glasses with long stems can
be placed upside down in theAfter loading your machine always close the door, as an
cup racks.open door can be a hazard.
For taller items, the cup
racks can be folded upwards.US47
Light items (plastic bowls
etc.) must be loaded in the
upper basket and arranged
so they do not move.
US73
In case that plates are loaded in the upper
basket:
load them starting from the
rear positions of the
basket; tilting them slightly
forwards and avoiding the
front positions near the
door.
US71
Before closing the door, ensure that the spray arms can
rotate freely.
9 |
ACEC
