Filling with saltRinse aid
Only use salt specifically designed for use inRinse aid is automatically added during the last rinse, ensuring
dishwashers.thorough rinsing, and spot and streak free drying. The
All other types of salt not specifically designed for use indispenser, which is positioned inside the door, holds about 110
a dishwasher, especially table salt, will damage the waterml of rinse aid, which is sufficient for 16 - 40 dishwashing
softener.programmes, depending upon the dosage setting.
Only fill with salt just before starting one of the washing
programmes.
This will prevent any grains of salt or salty waterFilling with rinse aid, which
may have been spilled, remaining on the bottom of the
1.Open the container by turning the lid (A) anticlockwise.
machine for any period of time, which may cause
corrosion.2.Add the rinse aid until the container is completely full.
The indicator (B) will be completely dark.
To fill:3.Top up the rinse aid when the rinse aid indicator light on the
control panel illuminates.
1.To fill with salt, unscrew
the cap of the salt
container.
2.Pour 1 litre of water inside
SALE
the container (this is SALT
SALZ
necessary only before
SEL
filling with salt for the first
time).
3.Using the funnel provided,
pour in the salt until the
BR01BR03
container is full.
Do not worry if water over SR06If rinse aid refilling is necessary, the rinse aid indicator
flows from the unit when light will illuminate only in setting mode and at the end of
filling with salt, this is quite normal.the washing programme.
4.Replace the cap making sure that there is no trace of salt During the run of the programme it will remain off.
on the screw thread or on the gasket.
Ensure that the lid is closed after every refill.
5.Screw on the cap tightly.
Do not put liquid detergent in the rinse aid compartment. Clean
up any rinse aid spilt during filling with an absorbent cloth to
The salt container will require topping up periodicallyavoid excess foaming during the next wash. .
You are reminded of this by the salt indicator light on theIt is possible to deactivate the rinse aid indicator light (see the
control panel which comes on when the salt has finished.following instructions).
The salt indicator light on the control panel can remainBy default the rinse aid indicator light is active.
illuminated for 2-6 hours after the salt has been
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer. The function of the machine is notTo deactivate the rinse aid indicator
affected.light ensure that the dishwasher is off
and then proceed as follows:
I
1.Press INTENSIVE SID 80and NORMAL programme push
buttons simultaneously.
2.While keeping the programme push buttons INTENSIVE
I
SID 80and NORMAL pressed switch on the dishwasher by
pressing the ON-OFF push button.
The ON-OFF indicator light comes on.
At the same time, the indicator lights of the INTENSIVE SID
I
80and NORMAL push buttons start flashing.
SO518
3.Press the NORMAL push button, the corresponding
indicator light keeps flashing while the indicator light of the
I
INTENSIVE SID 80push button turns off. At the same time
the indicator light end of programme starts to flash.
6 |
ACEC
