Operating sequence
1. Check the filters 9. At the end of the washing
Ensure they are clean and properly positioned programme
(see "Maintenance and cleaning").
At the end of the programme the
dishwasher will automatically stop.
The On/Off indicator light remains on until
2. Check that there is rinse aid the On/Off pushbutton is depressed.
and salt
10. Switch off the dishwasher
3. Load the dishes Switch off the dishwasher by pressing the
Remove any scraps of food.On/Off pushbutton and open the door.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
When the washing programme has
Slide the baskets back into the machine.finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
4. Ensure that the spray arms can
In general it is not advisable to open the
rotate freely.door while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
5. Measure out detergent
Add the required amount of detergent into the
dispenser according to the "Washing
programmes" chart.Caution
Do not open the door during the hot
Close the detergent dispenser lid.
phase: this may cause hot water escape.
Care must be taken if the door is opened
6. Close the dishwasher doorduring the hot phase or immediately
after a programme has finished, as
steam may escape.
7. Set the programme
Turn the programme selector dial clockwise until
the letter of the programme you wish to select
corresponds with the programme marker on the
control panel.
8. Start the programme
Depress the On/Off pushbutton.
The On/Off indicator light will come on and
the machine will start.
13SEQ09en |
ACEC
