Operating sequence
1. Check the filters 9. Start the programme
Ensure they are clean and properly Depress the On/Off button.
positioned (see cleaning instructions). The On/Off indicator light will come on
and the machine will start.
2. Check that there is rinse aid If you wish to interrupt the wash
programme at any time press the button
and salt again.
3. Load the dishes 10. At the end of the washing
Remove any scraps of food. programme
Pull the lower basket out and arrange the At the end of the washing programme the
saucepans, plates and cutlery in it.
machine stops automatically.
Pull the upper basket out and arrange the The On/Off indicator light remains on
plates, saucers, glasses and cups etc. in it. until the On/Off button is depressed.
Slide the basket back into the machine.
11. Switch off the dishwasher
4. Ensure that the spray arms can Switch off the dishwasher by pressing the
rotate freely. On/Off button and open the door.
5. Measure out detergent
When the wash programme has
Add the required amount of detergent into finished, it is recommended that the
the dispenser according to the OWashing dishwasher is unplugged and the water
programmes� chart and close the lid. tap turned off.
6. Close the detergent dispenser In general it is not advisable to open the
liddoor while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
7. Close the dishwasher door
Caution
Do not open the door during the hot
8. Set the programme
Turn the programme selector dial clockwisephase: this may cause hot water
until the letter of the programme you wish escape.
to select corresponds with the programme Care must be taken if the door is
marker.opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
37POS07GB |
ACEC
