Operating sequence
1. Check the filters 8. Start the programme
Ensure they are clean and properly positioned Close the door.
(see cleaning instructions). Depress the On/Off pushbutton. The On/Off
indicator light comes on and the machine will
2. Check that there is rinse start.
aid and salt9. At the end of the
washing programme
3. Load the dishes At the end of the washing programme the
Remove any scraps of food. dishwasher stops automatically. The On/Off
Pull the lower basket out and arrange the indicator light remains on until the On/Off
saucepans, plates and cutlery in it. pushbutton is depressed.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the basket back into the machine. 10. Switch off the
dishwasher
4. Ensure that the spray
Switch off the dishwasher by pressing the
arms can rotate freely.On/Off pushbutton.
5. Measure out detergent When the wash programme has
finished, it is recommended that the
Add the required amount of detergent into the
dispenser according to the "Washing dishwasher is unplugged and the
programmes" chart and close the lid. water tap turned off.
In general it is not advisable to open
6. Close the detergent the door while the machine is
working. If the door is opened
dispenser lidhowever, a safety device ensures
that the machine stops.
Care must be taken if the door is
7. Select the programme
opened during the hot phase or
The selection of a programme occurs with the immediately after a programme has
door partially opened.finished, as steam may escape.
Turn the programme selector dial clockwise
until the programme letter you wish to select
corresponds with the programme marker on the
control panel.
Select the temperature according to the
instructions in the "Washing programmes" chart
(see "Required pushbuttons).
16POS05UK |
ACEC
