Operating sequence
1. Check the filters 8. Start the programme
Ensure they are clean and properly positioned Depress the ON/OFF pushbutton.
(see "Maintenance and cleaning").
The ON/OFF indicator light will come on
and the machine will start.
If you wish to interrupt the washing
2. Check that there is rinse aid programme at any time press this button
again.
and salt
9. At the end of the washing
3. Load the dishes
programme
Remove any scraps of food. At the end of the programme the
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it. dishwasher will automatically stop.
The ON/OFF indicator light remains on until
Pull the upper basket out and arrange the the ON/OFF pushbutton is depressed.
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
If you select "HALF LOAD" programmes
10. Switch off the dishwasher
remember to load crockery, cutlery, pots and
pans only in the lower basketSwitch off the dishwasher by pressing the
ON/OFF pushbutton and open the door.
4. Ensure that the spray arms can
rotate freely.
When the washing programme has
finished, it is recommended that the
5. Measure out detergent dishwasher is unplugged and the water
tap turned off.
Add the required amount of detergent into the
dispenser according to the dosage intructions In general it is not advisable to open the
from the manufacturer of your brand. door while the machine is working;if the
Close the detergent dispenser lid.door is opened however, a safety device
ensures that the machine stops.
6. Close the dishwasher door
Important!
Care must be taken if the door is opened
7. Set the programmeduring the hot phase or immediately
Turn the programme selector dial clockwiseafter a programme has finished, as
until steam may escape.
the letter of the programme you wish to select
corresponds with the programme marker on the
control panel.
If necessary select the temperature of the main
wash according to the instructions in the
"Washing programmes" chart (see "Required
pushbuttons").
13SEQ18en |