Water outlet hose connectionElectrical connection
The end of the drain hose can be connected in the followingThis appliance must be earthed.
ways: The manufacturer declines any responsibility should this
1.To the sink outlet spigot, securing it to the underside of the safety measure not be observed.
work surface. This will prevent waste water from the sink If the plug that is fitted to your appliance is not suitable for the
running into the machine. socket, it must be cut off and the appropriate plug fitted.
2.Hooked over the edge of the sink using the special curved Important
plastic guide (if provided with the machine).The wires on the mains lead are coloured in accordance with
the following code:
3.To a stand pipe provided with vent-hole, minimum internal
diameter 4 cm. Green and Yellow - Earth
The waste connection must be at a height of between 30 cmBlue- Neutral
(minimum) and 100 cm (maximum) from the bottom of theBrown- Live
dishwasher. If you fit your own plug, the colours of the wires in the mains
The drain hose can face either to the right or left of thelead of your appliance may not correspond with the markings
dishwasher identifying the terminals in your plug.
Ensure the hose is not bent or squashed as this could preventProceed as follows:
or slow down the discharge of water.
1.Connect the Green and Yellow (earth) wire to the terminal
The sink plug must not be in place when the machine isin the plug which is marked with the letter "E" or the earth
draining as this could cause the water to syphon back into the
symbol or coloured green and yellow.
machine.
2.Connect the Blue (neutral) wire to the terminal in the plug
If you use a drain hose extension it must be no longer than 2
which is marked with the letter "N" or coloured black.
metres and its internal diameter must be no smaller than the
diameter of the hose provided. 3.Connect the Brown (live) wire to the terminal in the plug
which is marked with the letter "L" or coloured red.
E
13A
L
N
CS18
Likewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than the
diameter of the hose provided.
CE04
Attention!
Our appliances are supplied with a security device to protect
The plug moulded onto the lead incorporates a 13amp BSI362
against the return of dirty water back into the machine.
fuse. Only ASTA or BSI fuses should be used.
If the spigot of your sink has a "no return valve" incorporated
this can prevent the correct draining of your dishwasher. The plug must not be used if the fuse cover/carrier is lost. The
cover/carrier is indicated by the coloured insert at the base of
We advise you therefore to remove it.
the plug.
A replacement cover/carrier must be obtained from your local
Service Force Centre.
To isolate the dishwasher from mains, remove the mains plug.
Important!
The plug must still be accessible after the appliance
has been installed.
The appliance should not be connected to the
electrical supply by means of an extension cable.
In case that the electrical cable has to be replaced,
please contact your local Service Force Centre.
20 |
ACEC
