What to do, when...
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions
given here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation. All buttons are inoperative except for the On/Oftion off button and a combina
indicator lights, as indicated in the following chart, are flashing.
Open the dishwasherOs door and carry out the following suggested corrective actions.
Important:If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will
be made, even if the appliance is in guarantee.
Fault code / malfunctionPossible causeSolutions
- Indicator light of the The water tap is blocked or furred withClean the water tap.
programme in progress is limescale.
flashing. The water tap is turned off.Turn the water tap on.
- 1 flash of the indicator light
"END".The filter (where present) in the threaded hoseClean the filter in the threaded hose
fitting at the water inlet valve is blocked.fitting.
The machine does not fill withThe water inlet hose has not been correctly laidCheck the water inlet hose connection.
water.or it is bent or squashed.
- Indicator light of the The sink spigot is blocked.Clean out the sink spigot.
programme in progress is
flashing.
The water drain hose has not been correctly laidCheck the water drain hose connection.
- 2 flashes of the indicator light or it is bent or squashed.
"END".
The dishwasher will not drain.
- Indicator light of the Anti-flood device has activated.Close the water tap and contact the
programme in progress is Service Force Centre.
flashing.
- 3 flashes of the indicator light
"END".
Once the checks have been carried out, close the door and press the button of the programme that was running before the
intervention of the alarm, the programme will continue from the point at which it was interrupted. If the fault code reappears contact
the Service Force Centre.
For other combinations of fault codes not described in the above chart will appear, please contact your Service Force Centre.
...there are problems when operating the dishwasher
FaultPossible causeSolutions
The dishwasher door has not been properlyClose the door.
The programme does not startclosed.
The main plug is not plugged in.Insert the mains plug.
The fuse has blown in the household fuse box.Replace the fuse.
There is a whistling noise duringThe whistling is not a cause for concern.Use a different brand of detergent.
washing
16 |
ACEC
