6. Start the machine9. Opening the door after the
programme has startedBefore starting the machine check that:
Y the appliance is plugged in.Firstly, stop the machine by pressing
INeCIO / PAUSA button.Y the water supply tap is turned on.
After about one or two minutes the door can be
opened.Y the drain hose is correctly and securely positioned.
Y the door and the detergent dispenser drawer areIf the door does not open , this means that the
closed.temperature of the water is too high, that the water
To start the selected programme, push level exceed the lower limit of the door (which could
ENGLISH
INeCIO / PAUSA button; the corresponding light willcause overflowing) or that the drum is spinning.
stop flashing and will remain lit until the end of theIf the door cannot be opened but you need to open it,
programme.switch the machine off by turning the selector dial to
OO�. After approximately one or two minutes the door
can be opened. (PAY ATTENTION TO THE WATER
LEVEL AND TEMPERATURE!)
10. At the end of the programme
The machine stops automatically.
Release of the lock is indicated when FIM light
comes on.
Turn the programme selector dial to position OO� to
switch the machine off.
Remove the laundry from the drum and carefully
7. Modification of a runningcheck that the drum is empty.
If you do not intend to put in another wash, turn off
washing programme
the water tap. Leave the door open to prevent from
Once the programme has started, it only can beforming mildew and unpleasant smells.
modified by turning the programme selector dial to
OO� and afterwards the new programme can beATTENTION!
chosen.
The washing water remains in the tub, provided that
If the ANTI RUGAS option has been selected, thethe machine does not reach the rinse phase, since,
last rinse water does not drain. To drain the water,in this case, the machine drains it automatically.
carry out the following steps:
Start the new programme by pressing
INeCIO / PAUSA button.1. Turn the programme selector dial to OO�.
2. SelectESCOAMENTO orCENTRIFUGA?IO
programme.
8. Interrupting a programme
3. Press INeCIO / PAUSA button.
Depress INeCIO / PAUSA button to interrupt a
running programme, the corresponding light will
begin flashing. Press this button again to re-start the
programme.
39 |
ACEC
