132992820GB.qxd 23/06/2003 18:41 Pagina 83 (Nero/Process Black pellicola)
When the water has been drained, the display showsPress the SKIP/RESET button repeatedly to erase
a blinking zero. You may now select a newthe programme that has just been carried out. If
programme and press the START/PAUSE button toyou omit to do this, the next time you switch the
start it.washing machine on, the blinking zero will
appear on the display and you will hear the
audible signal.
12. How to cancel a programmeNote: when you switch the machine on, if you must
during its cycle
erase the previously performed programme, it is also
To cancel a programme that is being carried out, firstsufficient to press the FABRICS button and select a
pause the washing machine by pressing thenew programme.
START/PAUSE button, then press the SKIP/RESETPress the ON/OFF button to switch the machine off.
button repeatedly, until the display shows threeThe relevant light will go out.
blinking dashes.Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
13. How to open the door during therotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
cycle of a programmeaccidentally in the drum, where they might get
You can open the door, after having set the washingdamaged in a subsequent wash (e.g. by shrinking) or
machine to PAUSE, provided the followingbleed colour into another load of laundry.
conditions exist:We advise you to close the water supply tap and
the washing machine is not in the heating phasedisconnect the plug from the socket.
beyond 55°C;Leave the door ajar in order to air the washing
the level of the water is not high;machine.
the drum is not turning.
If these requirements are met, when you pause the
washing machine, the DOOR LOCKED light goes out
and the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by pressing the ON/OFF button.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the ON/OFF
button again, the washing machine will resume the
programme from the point where it had been
interrupted.
14. End of programme
At the end of the programme, the washing machine
stops automatically, gives an audible signal, and
displays a blinking zero.
If you had selected the NIGHT CYCLE option, the
START/PAUSE button light flashes to indicate that the
water must be drained. The display shows a steadily
lit zero.
When the programme has been completed, a
blinking zero appears on the display and the audible
signal is given.
The DOOR LOCKED light goes out at once.
83 |
ACEC
