132994360.qxd 6/6/02 4:19 PM Pagina 17 (Nero/Process Black pellicola)
If the filter is blocked and the machine is unable to drainClean the filter using a hard bristle brush.
you will need to drain the water manually from theTighten up the inlet hose.
machine at this stage. To do this, unhook the drain hose
from the standpipe or sink and hold the end of the hose
over a bowl on the floor. The water should drain by
gravity into the bowl. When the bowl is full, hook the
hose back up and empty the bowl. Repeat the procedure
until water stops flowing out.
Unscrew and remove the filter.
The dangers of freezing
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
ITurn off the water tap.
IUnscrew the inlet hose.
IUnhook the drain hose from the rear support and
Clean carefully under a fast running tap.position the end of this hose and that of the inlet
hoses in a bowl. Run the draining programme.
To do this:
ISwitch the machine on
ISelect a washing programme
IPress the SKIP/RESET button three times
IPress START/PAUSE button
IDisconnect the appliance.
IScrew the inlet hose and reposition the drain hose.
WarningIWhen you intend to start the machine up again, make
When the appliance is in use and depending on the
programme selected there can be hot water in the filter.sure that the room temperature is above 0°C.
Never remove the filter during a wash cycle, always
wait until the appliance has finished the cycle, and is
empty. When replacing the filter, ensure it is securely
retightened so as to stop leaks and young children being
able to remove it.
The water inlet filter
If your water is very hard or contains traces of lime
deposit, the water inlet filter may become clogged.
It is therefore a good idea to clean it from time to time.
Turn off the water tap.
Unscrew the water inlet hose.
17 |
ACEC
