132991610_GB.qxd 22/08/2003 16:40 Pagina 16 (Nero/Process Black pellicola)
7. Select the DELAY START11. Cancelling a programme
Turn the selector dial to O to cancel a programmeBefore you start the programme, if you wish the
which is running. Now you can select a newstarting to be delayed, press the DELAY START
button repeatedly, to select the desired delay. The
programme.relevant light illuminates.
12. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the8. Start the programme
selector dial to ?O?. After about 3 minutes the door can
To start the selected programme, press thebe opened (pay attention to the water level and
START/PAUSE button; the corresponding light stopstemperature!).
flashing.
The LAVADO (WASHING) light illuminates.13. At the end of the programme
The machine starts operating.
The machine stops automatically.
If the WET ANTI-ARRUGAS (RINSE HOLD) option
has been selected, the phase lights ?WET ANTI-
ARRUGAS? and ?FIN? (END) are on to indicate that
the water must be emptied out before opening the
door.
To do this first turn the programme selector dial to ?O?
and then to drain programme or spin programme
. The spin programme is
performed at the maximum speed. In order to avoid
If you have chosen a delayed start, the machine willany creasing or damage in synthetic, delicate and
begin the countdown.wool items, the spin speed must be reduced by
means of the relevant button.
9. Altering a programmeAt the end of the programme turn the programme
selector dial to ?O? to switch the machine off.
Remove the laundry from the drum and carefullyYou can alter the programme before it starts.
When the programme has started, you can only
check that the drum is empty.reset it by turning the programme selector dial to O
If you do not intend to carry out another wash, closeand then you can select the new programme.
the water tap. Leave the door open to prevent the
formation of mildew and unpleasant smells.The washing water remains in the tub.
Start the new programme by depressing the
START/PAUSE button.
10. Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart the
programme.
16 |
ACEC
