Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so that they
can be refitted if the machine ever has to be transported
again.
1. Using a spanner, unscrew and remove the rear
right-hand bolt and lay the machine on its back,
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing pieces
between the machine and the floor.
P0255
2. Remove the polystyrene block or blocks, depending
on the model from the bottom of the machine and
release the two plastic bags by removing the
adhesive strip.
3. Carefully remove the right-hand bag (1) then the 2
left-hand bag (2) by pulling them towards the centre1
of the machine.
P0802P0233
4. Set the machine u,pright and remove the two
remaining bolts from the back.
5. Pull out the three plastic spacers from the holes into
which the bolts were fitted.
6. Plug the open holes with the plugs which you will
find at the back of the appliance.
P0256P0020
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not
impeded by carpets, rugs etc. Check that the machine
does not touch the wall or other kitchen units.
Carefully level by screwing the adjustable feet in or out.
Never place cardboard, wood or similar materials under
the machine to compensate for any unevenness in the
floor.
P1051
24 |
ACEC
