Water inlet
Connect the water inlet hose to a tap with a 3/4"
thread after having inserted the small filter OA�ENGLISH
supplied with the machine.
The other end of the inlet hose which connectsA
to the machine can be turned in any direction.
Simply loosen the fitting, rotate the hose and
retighten the fitting, making sure there are noP0003P0021
water leaks.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.In this case, make sure the end
cannot come unhooked when the machine is
emptying.P0022
This could be done by tying it to the tap with a
piece of string or attaching it to the wall.
In a sink drain pipe brancThis brh. anch must
be above the trap so that the bend is at least
60 cm above the ground.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter of
the drain hose.
The drain hose must not be kinked. Run it along
the floor; only the part near the drainage point
must be raised.P0023
Electrical connection
The manufacturer declines any
This machine is designed to operate on a responsibility for damage or injury
220-230 V, single-phase, 50 Hz supply.through failure to comply with the above
Check that your domestic electrical installation
can take the maximum load required (1.75 kW),safety precaution.
also taking into account any other appliances inIn the event of replacing the electric
use.cable, please contact our nearest
Service Centre.
Connect the machine to an earthed socket,
in accordance with current wiring regulations.
7 |
ACEC
