132992270 gb.qxd 5/8/03 8:44 AM Pagina 5 (Nero/Process Black pellicola)
Installation
UnpackingPositioning and levelling
Install the machine on a flat hard floor.
All transit bolts and packing must be removed
Make sure that air circulation around the machine is
ENGLISH
before using the appliance.
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
You are advised to keep all transit devices so that
units.
they can be refitted if the machine ever has to be
Carefully level by screwing the adjustable feet in or
transported again.
out. Never place cardboard, wood or similar
1. Using a spanner, unscrew and remove the rear
materials under the machine to compensate for any
right-hand bolt and lay the machine on its back,
unevenness in the floor.
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing
pieces between the machine and the floor.
Water inlet
2. Release the two plastic bags by removing the
Connect the water inlet hose to a tap with a 3/4"
adhesive strip.
thread.
3. Carefully remove the right-hand bag (1) then the
The other end of the inlet hose which connects to the
left-hand bag (2) by pulling them towards the
machine can be turned in any direction. Simply
centre of the machine.
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
4. Set the machine upright and remove the two
remaining bolts from the back.
The inlet hose must not be lengthened. If it is too
5. Pull out the three plastic spacers from the holesshort and you do not wish to move the tap, you will
into which the bolts were fitted.have to purchase a new, longer hose specially
6. Plug the open holes with the plugs supplied withdesigned for this type of use.
the instruction booklet.
5 |
ACEC
