Something not Working
Problems may be due to causes which can easily be solved before calling the Technical Service. Please
follow these instructions:
SYMPTOMSOLUTION
Door does not closeWeight surpasses the storage limit of the door shelf so spread weight more evenly or
take some products out.
The appliance is not properly installed. Please look in the OBuilding-in� section.
It is too warm inside the refrigeratorSet a lower temperature.
Distribute the food products to allow cold air to circulate around them.
Make sure that the door is completely closed and that the insulating strip is complete
and clean.
The temperature where the cabinet is placed is above normal room temperature.
It is too cold inside the refrigerator.Turn the temperature regulator to a warmer setting temporarily.
The compressor works continuously.Turn the thermostat knob to a lower number.
The temperature where the cabinet is placed is above normal room temperature.
Check that the ventilation is sufficient and that the ventilation openings are
unobstructed.
The cause could be the introduction of large quantities of food and/or frequent
opening/closing of the door.
There is water inside/outside the refrigerator.Sometimes is normal. During automatic defrosting frost thaws on the cooling plate.
Water comes out on the floor.Place the drain hose at the back of the cabinet above the drain bowl.
NoisesSometimes this is normal. Temperature control may cause clicking sounds when the
system is connected or disconnected.
The injected cooling gas may produce a gurgling sound while passing through the
tubes.
The motor may cause a humming noise and/or slight bumping.
The insulation material used has a tendency to slighly increase noise levels, how ever it
allows for much better insulation and a lower energy consumption.
Customer service and spare parts
If you cannot find the remedy for a malfunction inThis information can be found on the rating plate
these operating instructions, please contact yourinside the cabenit on the left hand wall. We
dealer or our customer service department andrecommend that you enter this information here, so
consult the Guarantee card.that it is handy if needed.
Selective ordering of replacement parts can save
unnecessary travel and costs.
For this reason always provide the following
appliance information:
Y Model Name
Y Model Number (PNC)
Y Serial Number (S-No.)
Technical specifications
The technical data is indicated in the rating plate on the left side inside the appliance.
If there is a power failure when food is in the freezer, do not open the door of the freezer
compartment. The frozen food will not be affected if the power cut is of short duration (up to 12
hours) and the freezer compartment is full, otherwise, it is recommended that the food should be
used within a short time (a temperature increase of the frozen food shortens its safe storage
period).
41 |
ACEC
