OVEN DOOR
CARE AND MAINTENANCEFor some models, the oven door can be disassembled in the
following way:
hinges A are provided, for this purpose, with two movable jumpers
Before cleaning the appliance, disconnect the gas general
tap and unplug the appliance or disconnect power at the mainB; these, once hooked to the hinges slots C, when the door is
completely opened, block them. After that lift the door outward
circuit breaker of the electrical system.
Do not clean the appliance surfaces when still hot.carring out the two movements shown in the picture. To do that,
operate on the door sides next to the hinges. In order to re-
assemble the door, introduce the hinges in their relevant slots.
ENAMELLED SURFACES
Before closing the door, do not forget to remove the movable
Clean with a damp sponge using soap and water.jumpers B.
Grease can be easily removed using hot water or a specific
Attention, in proximity of the oven door hinges, there is hurt danger.
cleansing agent for enamelled surfaces. Do not use abrasive
cleansers.
Do not leave any acid or alkaline substances (lemon juiceFig., vinegar 27,
salt, etc.) on the enamel.
Clean the parts in stainless steel with specific cleansers for stainless
BC
steel surfaces.
These detergents must be applied using a soft cloth.
GRIDS AND BURNERS
To clean the work-top burners, remove them by pulling upwards
and soak them for about 10 minutes in hot water with a littleA
detergent. After having cleaned and washed them, wipe them
carefully.
Make sure that no burner hole is clogged.OVEN
Clean the burners once a week or more frequently if necessarClean the enamelled pary.ts with a damp sponge using soap and
MAKE SURE YOU HAVE ASSEMBLED THE BURNERS IN Awater. Grease can be easily removed using hot water or a specific
RIGHT WAY.cleansing agent for enamelled surfaces.
Do not use abrasive cleansers.
GLASS-CERAMIC SURFACE
To clean the work-top, you must follow the same precautions you
use to clean the glasses of your house. Soft stains caused by
SELF-CLEANING OVEN
aluminium pans bottoms can be removed by means of vinegar.In some models particular porosity of the oven inside sides enable
Make sure that sugar does not fall on the work-top during cooking,to absorb part of the grease, reducing it to little fragments which
if it falls disconnect the relevant hotplate, and clean as soon as
can be easily removed.
possible with hot water, before it gets cold.Make sure that these porosities are never stopped up by big
In case there are stains of burnt sugar or similars after cooking,
quantities of overflowing liquids. In this case, clean the part as
clean them using a spatule or a razor before the cooking zonesoon as the temperature goes down, using specific oven cleansers.
becomes cold (see picture).
In case of grease stains, clean the oven sides as follows:
let the empty oven operate at max. temperature for about 30
minutes, let it cool down, then clean the sides by means of a damp
cloth.
For some appliances, the self-cleaning side panels and the shelves
frame can be removed.
The shelves holder frame is hooked on to three catches. Simply
press the catches down slightly to remove the frame (Fig. 28A),
and this will also release the self-cleaning side panel (Fig. 28B).
To remove the rear self-cleaning panel (which also acts as the fan
Fig. 25guard), refer to Fig. 28C.
ELECTRIC HOTPLATESAB
After use, for a good conservation, the hotplate must be slighty
greased by means of a cloth soaked with oil, so that the surface
remains always clean and bright.
This avoids the eventual formation of rust too.
INSIDE OVEN GLASS
For some models, the inside glass of the oven door can be
disassembled for an easy cleaning.
In order to disassemble it, unscrew screws B as shown in the
picture.
C
Fig. 26Fig. 28
11 |
ACEC
