Turning Effects On and Off With Your Feet (Manual Mode)Changing the Sound of a Patch (Edit Mode)
Manual mode is a special mode in which you can use the foot switches to turn effect modules on and off or to The edit mode allows you to freely alter the parameters that make up a patch, so that you can create your own
change the rhythm pattern tempo. This is useful for example if you want to turn only certain effect modules on patches. This section describes how to do this.
and off during a performance.
INPUTOUTPUT
1.To switch the GFX-5 to manual mode, 3.To change the tempo of the rhythm
hold the BANK [Q] switch depressed pattern, tap the BANK [W] switch
patches from a preset group are read-only. When
while the unit is in play mode. repeatedly in the desired interval.
Patch conŢguration you have altered such a patch and you want to store
The indication OMANUAL� appears on the display, The interval of the last two taps is automatically
it, you must select a user group patch as store target
showing that the GFX-5 has switched to manual detected and taken as the new tempo.
Each patch of the GFX-5 consists of several effects (patch number 1 in the user group bank OU0� is
mode.
(effect modules), as shown in the illustration above. automatically preselected).
BPM 95A patch is a stored combination of modules, each
MANUALwith their distinct parameter settings. 2.To activate the edit mode, press the
[EDIT/EXIT] key.
Within each module, there are several different but The Ţrst time you switch to edit mode after the unit
related effects which are called effect types. For was turned on, the parameter PATLVL (patch level)
Tap repeatedly example, the MOD (modulation) module comprises of the TOTAL module will be selected.
effect types such as CHORUS, PHASER, and
WAH, of which one can be selected.
2.To switch effect modules on and off, press PATLVL20
one of the foot switches [1] - [3]. The elements that determine the sound of a patch
HINT
are called effect parameters. Each module has
When the GFX-5 is in manual mode, the modules By programming a patch beforehand to link the 3.Press the effect module key for the
certain effect parameters, whose value can be
DRIVE, MOD, and REV can be turned on and off ARRM control waveform (? p. 20) or the DELAY module that you want to edit.
adjusted with the effect module keys,
with foot switches [1] - [3]. The modules are TIME parameter of the REV module (? p. 34) to The effect type currently selected for that module is
the pattern tempo, you can control these PARAMETER [Q]/[W] keys, [VALUE] dial, etc.
assigned as follows. shown on the display.
parameters manually during a performance.
Lit: module is on 4.To return to play mode, press the BANK NOTE Effect type
Out: module is off
[Q] switch once more. Also within the same module, different effect
types will have different parameters.
ROOM
Basic edit mode steps HINT
If a module is selected that is currently off, the
This section describes the basic procedure for key ashes more slowly.
editing patches in edit mode. For information on
DRIVE module
effect types and parameters in the various modules, 4.To toggle the on/off status of the selected
MOD module
see the section OEffect Types and Parameters� on module, press the same key again while
REV modulepages 28 � 34. the effect type is being shown.
The effect type display changes to O-OFF-�.
1.In play mode, select the patch you want to
edit. To return the effect module to Oon� status, press the
Patches for editing can be selected from either a key again.
user group (U/u) or a preset group (A, b). However,
ZOOM GFX-5ZOOM GFX-5
1617 |
ACEC
