In play mode, when a patch where JAM PlayThe function of the t foot switch and expression
can be used is selected, the REV and PEDALpedal depends on the STYLE parameter and
module LEDs are flashing. TRG/GT parameter setting.
When "nM" or "rS" is selected as STYLE
7Push down the expression pedal fully.
parameter, the expression pedal can be used to
The GFX-707 enters the Jam Play mode andadjust the level of the playback signal.
goes into the recording standby condition. The
indication "JP" is shown on the BANK/PATCH
To record and play a new phrase, repeat steps
indicator.
8 - 10.
8While playing your instrument, press the s
11To terminate the Jam Play mode, push the
foot switch when you want to startexpression pedal once more fully down or
recording.
press the EDIT (CANCEL) key.
As opposed to the regular sampler function, the
Also after terminating the Jam Play mode, the
signal recorded for Jam Play always is
most recent recorded phrase is temporarily
processed by the currently selected effects. retained by the unit and can be used again
when a patch is selected for which Jam Play is
9To stop recording midway, press the t
enabled. If Jam Play is enabled for both
foot switch. Alternatively, after 2 seconds,
patches, it is also possible to switch between
recording stops automatically.
patches while playing the recorded phrase.
10Use the tfoot switch or the expressionWhen the regular sampler is used or when the
unit is turned off, the phrase is cleared.
pedal to control play/stop of the recorded
phrase.
ControllinganEffectWiththePedal
Controlling an Effect With the Pedal
The expression pedal of the GFX-707 can be used to control the volume or parameters of the COMPYDIST, MOD,
and REV modules in real time.
1In edit mode, use the MODULE /keys3Use parameter knob 2 to select the way
to cause the PEDAL module LED to flash. the parameter changes when the pedal is
When wishing to control a parameter with themoved.
expression pedal, the parameter must first beParameter 2 is the MODE parameter that
assigned to the pedal in edit mode. determines the range and direction of the
change caused by the expression pedal.
2Use the parameter knob 1 to select the
Available settings are "UP", "dn" (Down), Hi
assign target for the expression pedal.(High), Lo (Low).
Parameter 1 of the PEDAL module is the
Parameter value
ASSIGN parameter.Maximum value
The following targets can be selected: "VL"UP
Hi
(Volume), "dS" (COMPYDIST module), "Md"dnValue
programmed
(MOD module), "rv" (REV module). When ain patch
Lo
module to which the pedal is assigned is called
up, the indication "Pd" appears on theMinimum value
BANK/PATCH indicator.
The parameter that is actually controlled is4Store the patch and return to the play
predetermined for every effect type in themode.
module. This parameter is indicated by a pedal
Verify that the module to which the pedal was
mark in the description on pages 17 through 20.
assigned is ON.
ZOOM GFX-70722 |
ACEC
