Trying Out the GM-200
To use the GM-200 for creating various types of sound, perform the following steps.
1.Select the output character
Use the OUTPUT CHARACTER knob to choose
among the various options, as described on page
8. Make the setting to match the type of system to
which the GM-200 is connected.
2.Select the amp type
Use the AMP SELECT knob to choose the guitar
amplifier type that is simulated by the unit, as
listed on page 9.
TryingOuttheGM-200
Adjust distortion intensity and
3.
volume
Use the GAIN control to adjust the distortion
intensity. Because turning up this control not only
increases distortion but also raises the volume level,
use the MASTER LEVEL control as necessary to
adjust the level.
4.Adjust ZNR (Zoom Noise Reduction)
Use the ZNR control to set the threshold for the ZNR circuit that reduces noise
during play pauses. When the control is turned fully to the left, ZNR is off.
Turning the control to the right gradually raises the action threshold. Set the
control to achieve maximum noise reduction without causing the sound to be
cut off unnaturally.
The optimum ZNR point will differ for various amp
NOTE
types and gain settings. Readjust the ZNR control if
you have changed the setting of the AMP SELECT
knob or the GAIN control.
6ZOOM GM-200 |
ACEC
