To Replace:
1. Hold oven door by the handle and place the top of the door
Appliance Outlets
under the cooktop overhang.
(on some models)
2. Use front of leg to apply pressure to slide hinges into the slots
The 120v appliance outlets located on the control console may as far as possible.
be used to run portable appliances placed on countertops beside
3. Use side of leg to apply pressure to the bottom of the door
the range.
front.
The outlets operate independently and are not affected by range
4. Lift door slightly. Apply pressure and push until the hinges
control settings.
have gone in fully.
NOTE: Do not place appliances on the cooktop. Damage to the
5. Fully open the door.
appliance could result if the cooktop is hot.
6. Tighten clips with a #2 square or Phillips screwdriver.
Appliance Outlet Circuit Breakers:
The circuit breakers for the appliance outlets on your range are
located under the cover on top of the control console. They are
rated for 12 amps.
Lift the cover by lifting the front edge at both ends.
On models equipped with a fluorescent cooktop light, remove the
fluorescent tube to gain access to the circuit breakers.
Oven DoorStorage Drawer
For normal range use, it is not suggested to remove the oven The storage drawer can be removed. Before removing, make sure
door. However, if removal is necessary, make sure the oven is off drawer is cool and empty.
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
To Remove:1. Pull drawer straight out to the first stop.
1. Fully open the oven door.
2. Lift up the back of the drawer and pull out.
2. Unscrew clips with a #2 square or Phillips screwdriver.
To Replace:
1. Fit the ends of the drawer rails into the guides in the cavity.
2. Slide the drawer closed.
Sweep-Thru Base
When the storage drawer is removed, the sweep-thru base
makes cleaning easier and provides access to the leveling legs.
1
3. Close oven door to the stop position (open about 4 in.
[10 cm]).
4. Lift door slightly and pull out and back until hinges come out 1. Sweep-thru base
to the catch position.
5. Push door down and pull straight out to remove door
completely.
4" (10 cm)
4"
20 |
ACEC
WHIRLPOOL
