E. Resist quantity adjustmentG. Manual feed section
This adjustment is performed in the following cases:paper guide position adjustment
?When the void quantity is changed by the paper feed trTahisy. adjustment is performed in the following cases:
?When paper feed skew occurs.?When the duplex unit with the manual feed unit is installed.
Before executing this adjustment, the following adjustments? Wmhen ust thahe vemanual feed tray paper size detection fails.
been completed. 1) Hold and push the [MENU] key and the [OK] key, turn on the power.
?LSU right-angle adjustment("PCU DIAG MODE ***" is displayed.)
?Print magnification ratio adjustment*Do not touch the keys for about 8sec after releasing fingers from
?Print off-center adjustmentthe above keys.
?Void area adjustment
1) Hold and push the [MENU] key and the [OK] key, turn on the power.
("PCU DIAG MODE ***" is displayed.)
" ON "
*Do not touch the keys for about 8sec after releasing fingers from
the above keys.
2) Push the [MENU] key several times until "TEST PRINT" is displayed,
and push the [OK] key to enter the test print mode.
3) Make a print with "71" from each paper feed tray.
4) Push the [MENU] key several times until PAPER BUCKLE is
2) Push the [MENU] key several times until "SIZE ADJUSTMENT A" is
displayed.
displayed, and push [ ] key to display "SIZE ADJUSTMENT B" and
Adjust the resist quantity so that paper is transported normally.
push the [OK] key.
<Factory setup>3) "MAXIMUM SIZE" is displayed on the LCD.
PAPER45CPMMFT60Check the value displayed with MAXIMUM SIZE. Use [ ] or [ ]
BUCKLET170key to make the displayed value same as the MAX value specified on
T255the label (* Note).
T355
4) "P1 SIZE" and a value are displayed. Use [ ] or [ ] key to make
T460
the displayed value same as the P1 value specified on the label
35CPMMFT65
(* Note).
T175
5) "P2 SIZE" and a value are displayed. Use [ ] or [ ] key to make
T260
the displayed value same as the P2 value specified on the label
T360
T465(* Note).
6) "MINIMUM SIZE" and a value are displayed. Use [ ] or [ ] key to
F. Option paper feed tray paper guide adjustment
make the displayed value same as the MIN value specified on the
This adjustment is performed in the following cases:label (* Note).
?When the option paper feed tray is installed.
?When the paper size detection fails.(*Note) Label attachment position
1) Hold and push the [MENU] key and the [OK] key, turn on the power.
("PCU DIAG MODE ***" is displayed.)
*Do not touch the keys for about 8sec after releasing fingers from
the above keys.
2) Push the [MENU] key several times until "SIZE ADJUSTMENT A" is
displayed, and push the [OK] key.
3) "MAXIMUM SIZE" is displayed on the LCD.
Pull out the cassette, open the paper guide to the maximum, returnLabel
the cassette to the machine, and push the [OK] key.
4) "MINIMUM SIZE" is displayed on the LCD.
Pull out the cassette again from the machine, close the paper guide
to the minimum, return the cassette to the machine, and push the
[OK] key.
AR-P350 ADJUSTMENTS-5 |