Installation
Transit security barsHydraulic connection
Before starting the machine up, the transport
There should be a COLD WATER tap near the
security bars must be removed as follows:ENGLISH
washing machine with a screwing on connection
You are advised to keep all the transport security
3
bars in case the appliance has to be transportedpipe of �4� gas for the water supply, a sink, a wash
basin or a drainage system in the wall.
again.
Previously check if:
1. Unscrew and remove
N it is not a hot water tap.
the three rear screws
by means of a key.N the running water is clean. If not, run off a
reasonable amount of water to flush out any
debris that may have collected in the pipes.
Have the permanent drainage system in the wall
checked by a plumber.controlar su buen estado por
P0287un fontanero.
A) Place the enclosed
rubber joint, delivered in
2. Lean the appliance
a plastic bag together
back on the rear and
with the appliance (A)
fit one of theA
Fig.6), at the very end of
polystyrene angles
the inlet hose and
between the appliance
carefully screw the pipe
and the floor.
to the tap taking care not
AL013
to damage the
Make sure the hoses
P0018screwdrive and fix the
are not squashed.
nut well on to the end in
order to avoid leaking.
B) If necessary turn the
3. Carefully remove the
hose adequately by
plastic bags on the
unscrewing the nut at the
right and the left,
rear of the appliance.
pulling them to the
1centre of the appliance
C) Now tighten the nut
2
anew to avoid leaks.
(Open the tap and asure
P0021
AL009that it does not leak and
close it again.)
D) Place the discharging
hose in a washbasin or
sink with the aid of the
bent piece delivered
separately. The bent
piece has to be entered
into the tubeOs mouth in
order to assure the
P0001P0002
support. Aforesaid piece
allows the hose to be
4. Place the machine in an upright position and
fixed to the wall by means
remove the three plastic bolts.
of an opening on the
5. Plug the 3 holes with the plastic plugs which youupper part and that way
can find in the envelope containing the instructionthe hose does not move
booklet.and its falling is avoided.
7 |
ACEC
