CONNECTIONS
Do not use the dishwasher if it has been
damaged in transit. Consult our After-Sales
Service or your local retailer.
(Refer to the separate assembly instructions
booklet)
Water inlet and drain:
? Observe any special regulations issued by
your local Water Board.
? Make sure the inlet and drain hoses are kink-
free and are not crushed.
? If the hose length is not sufficient, please
contact your local dealer or our After-Sales
Service.
? The inlet hose must be securely clamped to
the water tap to prevent leaks.
? The water inlet pressure should not be less
than 0.3 bars.
? If the water inlet pressure is higher than
10 bars, a pressure reducing valve should be
fitted between the appliance inlet and the
water source.
? The inlet water temperature varies according
to the model installed: inlet hose marked ?25° C
Max?: maximum temperature 25° C.
All other models: maximum temperature 60° C.
? When installing the appliance, make sure the
drain water discharges correctly (if
necessary, remove the wire gauze from
the sink siphon).
? Fix the drain hose to the siphon with a clamp
to prevent it from coming off during operation.
? For appliances with water-stop system only:
If the water connections are made correctly
according to the instructions, the water-stop
system safeguards your home against
damage caused by flooding.
Electrical connection:
? Observe the current regulations issued by
your local electricity supplier.
? Voltage information is shown on the rating
plate mounted inside the door on the right
hand side.
? The appliance must be earthed as prescribed
by law.
? Do not use extension leads or multiple
adapters.
? Before carrying out maintenance, disconnect
the mains plug.
? The power cable must only be replaced by a
qualified technician.
? The manufacturer cannot be held
responsible for damage caused by incorrect
earthing of the appliance.
? For Austriif the apa: pliance is series
connected to a fault current switch, this must
be sensitive to the pulsating current.
12 |