CS50-60-80 OM 8/6/04 1:18 PM Page 6
EXISTING CONSTRUCTION
CS 50, CS 60CS 60R, CS 60RDT, CS 80R
Template
1. Remove the grille from the2. Determine the correct
speaker frame.
1. Remove the grille from2. Determine the correct speaker location.
the speaker frame.speaker location.NOTE: Remove the inner
NOTE: Remove the innertemplate, which is the paint
template, which is the paintshield, at the perforation. Use
shield, at the perforation. Usethe outer template when
the outer template when cuttingcutting the drywall.
the drywall.
e1/2"
e1/2"e1/2"
e1/2"e1/2"e1/2"
3.Determine the correct speaker 4.Cut the drywall.
location.
3. NOTE: Always allow at least 4. Cut the drywall.NOTE: Always allow at least one-
one-half inch between a wallhalf inch between a wall stud
stud and the speaker cutout orand the speaker cutout,or the
the locking tabs will not belocking tabs will not be able to
able to swivel into place.swivel into place.
5. Connect the speaker wires to6. Place the frame
the speaker. Model CS 60RDTassembly in the wall.
requires two sets of speaker
5. Connect the speaker6. Place the speakerwires, one for each channel.
wires to the speaker.assembly in the wall.
7. Screw down each of the8. Replace the metal grille.7. Screw down each of the four8. Replace the metal grille.
Phillips head screws.ThePhillips head screws.The
locking tabs will swivel intolocking tabs will swivel into
place and secure the unit to theplace and secure the unit to
the rear surface of the drywall.
rear surface of the drywall.
6CS SERIES |