ECS300 Simply Cinema OM 7/21/98 3:06 PM Page 10
Troubleshooting
If there is no sound fromIf there is no sound fromIf there is no sound from
any of the speakers, checkthe surround speakers or the center speaker, check
the following:it is very low, check the the following:
following:
Y Make sure the subwoofer isY Make sure that the proces-
plugged into an active ACY Check all connectionssor is in the Pro Logic,
wall outlet.between processor/amplifier3 Stereo, or Simulated mode.
Y Make sure the Master Powerand each of the speakers.If it is in Phantom or Stereo
Switch, located on the rear ofY Raise the surround volumemode, the center speaker
the subwoofer, is in thefrom the remote control (seewill not play.
�On/StandbyO position.OOperationO section).Y Check the connections
Y Make sure there is a Y Make sure the TV show orbetween the subwoofer and
source � for example, a VCRmovie you are watching isthe center speaker.
or television hooked up torecorded in Dolby Surround.
the video or auxiliary inputIf it is not, try the PhantomIf you have low bass output,
check the following:
jacks.or Simulated surround mode.
Y Make sure that the programY Experiment with placement
material is playing.of the subwoofer. Remember,
Y Recheck the hookup con-place the subwoofer in a
nections in the �Speakercorner to get maximum bass
ConnectionsO section.output from the system.
Y Increase the level of bass,
using the remote control.
Specifications
ESC300 SystemSubwoofer Satellites (each)
AmplifierDimensions (HxWxD)Dimensions (HxWxD)
200 watts total 15-1/8 x 13 x 14-1/2 inches 4-3/8 x 3-3/16 x 3-3/4 inches
system output; 384 x 330 x 368mm111 x 81 x 95mm
front channels: Weight Weight
35 watts x 3 @ .1% THD; 34.5 lbs/15.7 kg.8 lbs/.4 kg
surround channels:
15 watts x 2 @ .1% THD;
subwoofer:
65 watts x 1 @ 1% THD
Signal-to-Noise Ratio
90dB
Input Impedance
20k ohms
Input Sensitivity
400mV
Auto Turn-on Sensitivity
2mV/channelOccasional refinements may be
System Frequency made to existing products
Response (�6dB)
35Hz � 20kHzwithout notice, but will always
meet or exceed original
specifications unless otherwise
stated. |