6gb55003a.fm Page 27 Thursday, March 18, 2004 11:39 AM
TROUBLESHOOTING GUIDE
Oven not working:IMPORTANT:
?Check for the presence of mains electrical power ?Check that the oven control knob is not turned
and if the oven is connected to the electrical to ?0? or to ?lamp? .
supply.
If the electronic programmer (depending on
?Turn off the oven and restart it to see if the fault model) display presents the message
persists.??, consult the product description
The door is locked and will not release:sheet provided separately and/or the
electronic programmer description.
?Turn off the oven and restart it to see if the fault
persists.- If the electronic programmer (depending on
the model) presents the message ?F XX?,
contact the nearest After Sales Service.
Specify in this case the number that follows
the letter ?F?.
AFTER SALES SERVICE
Before you call the After Sales ServiceIf any repairs are required, please contact an
1. Try to solve the problem yourself following authorised After Sales Service (to guarantee
the points described in ?Troubleshooting that original spare parts will be used and repairs
Guide?.carried out correctly).
2. Turn the appliance off and on again, to make Failure to comply with these instructions may
sure that the problem has been solved.compromise the safety and quality of the
If after the above checks the fault still occurs, product.
get in touch with the nearest After Sales
Service.DECLARATION OF CONFORMITY
Please give:?These appliances are intended to come into
?a short description of the fault;contact with foodstuffs and they are
constructed in compliance with Directive
?the oven type and model;89/109/EEC.
?the service number (number after the word
Service on the rating plate), located on the ?This appliance is designed to be used for
right hand edge of the oven cavity (visible cooking only.
when the oven door is open). The service Any other use (for example, for room
number is also indicated on the guarantee heating) is considered as improper use and
potentially dangerous.
booklet;
?your full address;?This appliance has been designed,
constructed and marketed in compliance
?your telephone number.with:
- The safety requirements of ?Low
Voltage? Directive 73/23/EEC;
- the protection requirements of EMC
Directive 89/336/EEC
- the requirements of Directive 93/68/EEC.
27 |
ACEC
WHIRLPOOL
