10109P2GS3CM25DDC Instructions (Continued)
Gotocoverpage
DDC Reprogramming Instructions (forHow to write DDC hex files to Monitor
PHILIPS models)
Use arrow keys to highlight "Options" under the Setup menu,
press "Enter"
System Requirements
DDC Module (DDC cable), P/N = 4822 320 12004Tab down to ID Serial Number, use down arrow key to place
An Intel 386 (or above) PC or compatible
the asterisk (*) beside "store in DEC with LSB first". Press
DOS 6.0 or above
"control/enter" to save.
DDCV2A.EXE software
(Ensure the top asterisk (*) is beside in store in HEX with LSB
first.)
Procedure
Use arrow keys to highlight "Load EDID" under the file menu,
Connect DDC Cable between PC and Monitor.
Turn on Monitor and PC.press "Enter".
Access Factory Mode of monitor.
Verify Factory Mode by OSD function of monitor.Use arrow keys to highlight "PHILIPS\", Press "Enter".
Insert diskette in Drive a: Select Run "DDCV2A F0(Zero).EXE"under
DOSorWin.(hit the space bar once )Use arrow keys to highlight "the model list under subdirect",
press "Enter".
Verify the data and version of DDC application software.
It should be : January 31 2000
Use arrow keys to highlight "Write EDID to EEPROM" under
Revision 3.3
the R/W menu, press "Enter".
Press "Enter" at the introduction screen
Use arrow keys to highlight "Read from EEPROM" under the
R/W menu, press "Enter".
Menu Configuration:
Use arrow keys to highlight "Edit EDID Code" under the R/W
FileR/WSetupQuit
menu, press "Enter".
Load EDIDWrite EDID to EEPROM Options
Verify the ID Serial number on the screen matches the serial
Load txt file (V1.0)Read From EEPROMBarcode format
Save EDIDEdit EDID Codenumber of the unit.
Save txt FileAuto Scan
Convert EDID Code
Verify EDID Structure Version is "Version :2, Revision :1
Os shell
Exit11
Press "ESC"
General :12Use arrow keys to highlight "Quit", Press "Enter".
1.Howtochangedrive
Use arrow keys to highlight "Options" under the Setup
menu, press "Enter".
Press "F2", then press "ESC", fill in "A" or "C".Menu Configuration:
[(If your .HEX files for different Model numbers in drive "A",
then fill in "A").,FileR/WSetupQuit
(If your .HEX files for different Model numbers in drive "C",
then fill in "C").Load EDIDWrite EDID to EEPROM Options
Normally, to read DDC data from EEPROM of Monitor isLoad txt file (V1.0)Read From EEPROMBarcode format
Save EDIDEdit EDID Code
enough.]
Save txt FileAuto Scan
Press "Enter", then press "ESC"
Convert EDID Code
Os shell
2. Howtoselect.HEXfilesfordifferentModelnumbers
Exit
example:
Use arrow keys to highlight "Load EDID" under the File
menu, press "Enter"
109P2 GSIII select, press "Enter"
"Enter", then go back to last
screen
00MITS.HEX select for 109P20/00(MITS CRT)
BackForward |
ACEC
PHILIPS
