BM 1619929472 2/03 2/12/03 2:45 PM Page 2
Power Tool Safety Rules
Read and understand all instructions. Failure to follow all instructions
listed below, may result in electric shock, fire and/or serious personal injury.!WARNING
SAVE THESE INSTRUCTIONS
Work AreaWhen operating a power tool outside, use
an outdoor extension cord marked "W-A"
Keep your work area clean and well lit.
Cluttered benches and dark areas inviteor "W." These cords are rated for outdoor use
accidents.and reduce the risk of electric shock. Refer to
ORecommended sizes of Extension Cords� in
Do not operate power tools in explosivethe Accessory section of this manual.
atmospheres, such as in the presence of
flammable liquids, gases, or dust. PowerPersonal Safety
tools create sparks which may ignite the dustStay alert, watch what you are doing and
or fumes.
use common sense when operating a
Keep by-standers, children, and visitorspower tool. Do not use tool while tired or
away while operating a power tool.under the influence of drugs, alcohol, or
Distractions can cause you to lose control.medication. A moment of inattention while
operating power tools may result in serious
Electrical Safetypersonal injury.
Double Insulated tools are equipped withDress properly. Do not wear loose clothing
a polarized plug (one blade is wider thanor jewelry. Contain long hair. Keep your
the other.) This plug will fit in a polarized
hair, clothing, and gloves away from
outlet only one way. If the plug does notmoving parts. Loose clothes, jewelry, or long
fit fully in the outlet, reverse the plug. If ithair can be caught in moving parts. Keep
still does not fit, contact a qualified
handles dry, clean and free from oil and
electrician to install a polarized outlet. Dogrease.
not change the plug in any way. Double
Insulation eliminates the need for theAvoid accidental starting. Be sure switch is
three wire grounded power cord andOOFF� before plugging in. Carrying tools with
grounded power supply system. Beforeyour finger on the switch or plugging in tools
plugging in the tool, be certain the outletthat have the switch OON� invites accidents.
voltage supplied is within the voltage markedRemove adjusting keys or wrenches before
on the nameplate. Do not use OAC only�turning the tool OON�. A wrench or a key that
rated tools with a DC power supply.is left attached to a rotating part of the tool
Avoid body contact with grounded surfacesmay result in personal injury.
such as pipes, radiators, ranges andDo not overreach. Keep proper footing and
refrigerators. There is an increased risk ofbalance at all times. Proper footing and
electric shock if your body is grounded. Ifbalance enables better control of the tool in
operating the power tool in damp locations isunexpected situations.
unavoidable, a Ground Fault Circuit InterrupterUse safety equipment. Always wear eye
must be used to supply the power to your
tool. ElectricianOs rubber gloves and footwearprotection. Dust mask, non-skid safety
shoes, hard hat, or hearing protection must be
will further enhance your personal safety.used for appropriate conditions.
Don't expose power tools to rain or wet
conditions. Water entering a power tool willTool Use and Care
increase the risk of electric shock.Use clamps or other practical way to
secure and support the workpiece to a
Do not abuse the cord. Never use the cord
to carry the tools or pull the plug from anstable platform. Holding the work by hand or
outlet. Keep cord away from heat, oil, sharpagainst your body is unstable and may lead to
loss of control.
edges or moving parts. Replace damaged
cords immediately. Damaged cords increaseDo not force tool. Use the correct tool for
the risk of electric shock.your application. The correct tool will do the
-2- |
ACEC
BOSCH
