BM 1619929701 11-05 11/14/05 4:48 PM Page 11
SLIP CLUTCHBRAKE
The tool has a internal pre-set slip clutch.When the trigger is released it activates the
The output spindle will stop rotating if theelectrical brake to stop the chuck quickly.
accessory binds and overloads the tool.This is especially useful in the repetitive
driving and removal of screws.
BATTERY CHARGED CONDITIONYWhen only one light illuminates, this
INDICATORindicates the battery pack is less than 33%
The battery is equipped with a chargedcharged.
condition indicator.
When one light blinks the battery pack is
GREENalmost fully discharged.
INDICATOR LIGHTS
TEMPERATURE INDICATOR LIGHT
The red indicator light signals whether the
with battery inserted
optimum temperature range. When the
temperature is too high, the tool will not
operate at full capacity.
RED
BUTTONIf the red indicator light illuminates
INDICATOR LIGHT
continuously when the battery is inserted into
the charger. The battery is outside the
By pressing the button ON, the charged
charging temperature range and cannot be
condition can be checked when the battery is
charged.
removed or when the machine is not in use.
After approx. 5 seconds, the chargedIf the red indicator light blinks when the
indicator switches off automatically.with battery inserted
is pressed, the battery is outside the
Y Y Y When all three lights are illuminated,
operating range of -10 uC to +60 uC.
this indicates the battery pack is between
67% and 100% charged.When the temperature is above 70 uC the
battery turns off until itOs in the optimum
Y YWhen only two lights illuminate, this
temperature range.
indicates the battery pack is between 33%
and 66% charged.
INSERTING AND RELEASING BATTERY PACK
Set Forward/Reversing lever to the center (offpack from completely falling out of the handle,
position). Slide charged battery pack into theshould it become loose due to vibration.
housing until the battery pack locks intoTo remove the battery pack, press the battery
position and the red warning label is no longerpack release button and slide the battery pack
Fig. 1forward. The red warning label will become
Your battery pack is equipped with apartially visible. Press the battery pack release
secondary locking latch to prevent the batterybutton again and slide the battery pack
completely out of tool housing.
CHARGER INDICATORS, SYMBOLS AND MEANING
If the indicator lights are OOFF�, the chargerIf the green indicator light is
is not receiving power from power supplyOBLINKING�, the battery pack is
outlet.being fast-charged. Fast-
charging will automatically stop when the
If the green indicator light is
battery pack is fully charged.
OON�, the charger is plugged in
but the battery pack is not
inserted, or the battery pack is fully charged.
-11- |
ACEC
BOSCH
