Troubleshooting
If the fault cannot be corrected by using this guide, remove the mains plug from the wall socket and
contact the dealer or supplier from whom it was purchased. Where this is not possible, please visit our
web-site at www.sharp.co.uk/support. Customers without internet access may telephone 08705
274277 during office hours (or (01) 676 0648 if telephoning from Ireland).
Certain replacement parts and accessories may be obtained from our Main Parts Distributor, who can
be contacted on the following numbers:
Willow Vale Electronics Ltd.
0121 766 5414 and 0161 205 7531
In the unlikely event of this equipment requiring repair during the guarantee period, you will need to
provide proof of the date of purchase to the repairing company. Please keep your invoice or Receipt,
which is supplied at the time of purchasing.
us
ute
Quickast setting in
Servicek for possible
Check List
Possible Causes/Solutions
ProblemsTry a new channel to checstation troubleThe TV set not plugged in Outlet power OFFPower button of the TV set not onAntenna not connected to terminal at the back of the TV setIf outside antenna is used, check for broken wiresCheck for local interferenceTurn off the TV set by pressing the Power button on the TV set, then turn on again after a minAdjust COLOUR controlCheck batteries in the Remote ControlTry fine tuning to correctCheck if the Brightness or ContrPicture Adjustment might be set to the minside.Increase the volume
Remote control does not work
Bars on screen
Picture distorted
Picture rolls vertically
No colour
Poor reception on some channels
Picture weak
Picture lines or streaks
Picture ghosting
Picture blurred
Sound OK, picture poor
Picture OK, sound poor
No picture or sound
This TV set is equipped with a microprocessor. Its performance could be adversely affected by external
electrical noise or interference. If this should happen, unplug the TV set and plug it in again after a few minutes.
27 |
ACEC
SHARP
