19R-M100
19R-M100S
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:WAVEFORM MEASUREMENT CONDITIONS:
1. The unit of resistance "ohm" is omitted.1. Photographs taken on a standard gated color bar
(K=k& =1000& , M=M& )signal, the tint setting adjusted for proper color. The
2. All resistors are 1/10 watt, unless otherwise noted.wave shapes at the red, green and blue cathodes of
3. All capacitors are ?F, unless otherwise noted.the picture tube depend on the tint, color level and
(P=pF=??F)picture control.
4. (G) indicates ?2% tolerance may be used.2. indicates waveform check points (See chart,
5. indicates line isolated ground.waveforms are measured from point indicated to
chassis ground.)
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connectedaAND SHADED ( ) COMPONENTS
between points indicated and chassis ground, line= SAFETY RELATED PARTS.
voltage set at 120V AC and all controls set for normal'MARK= X-RAY RELATED PARTS.
picture unless otherwise indicated.
2. All voltages measured with 1000? V B & W or ColorThis circuit diagram is a standard one, printed
signal.circuits may be subject to change for product
improvement without prior notice.
WAVEFORMS
1.01.00.95.05.02.11.0
1.225474.60.73339.0
11602201501332201.70.7
1.410595105
13 |
ACEC
SHARP
