MECHANICAL ALIGNMENT PROCEDURES
[ 21PV375/(01, 07, 58, 39) ]
Explanation of alignment for the tape to correctly runB. Method to place the Cassette Holder in the tape-
starts on the next page. Refer to the information belowloaded position without a cassette tape
on this page if a tape gets stuck, for example, in the1. Disconnect the AC Plug.
mechanism due to some electrical trouble of the unit.
2. Remove the Top Case and Front Assembly.
Service Information3. Turn the LDG Belt in the appropriate direction
A. Method for Manual Tape Loading/Unloadingshown in Fig. M1. Release the locking tabs shown
in Fig. M1 and continue turning the LDG Belt until
To load a cassette tape manually:the Cassette Holder comes to the tape-loaded
1. Disconnect the AC plug.position. Allow a minute or two to complete this
2. Remove the Top Case and Front Assembly.task.
3. Insert a cassette tape. Though the tape will not be
automatically loaded, make sure that the cassetteTop View
tape is all the way in at the inlet of the Cassette
Moving guide T preparation
Holder. To confirm this, lightly push the cassette
tape further in and see if the tape comes back out,(Eject Position)LOAD
Moving guide S preparation
by a spring motion, just as much as you haveUNLOAD
(Eject Position)
pushed in./EJECT
4. Turn the LDG Belt in the appropriate direction
Side View
shown in Fig. M1 for a minute or two to complete
this task.
To unload a cassette tape manually:
1. Disconnect the AC plug.
2. Remove the Top Case and Front Assembly.LDG Belt
3. Make sure that the Moving guide preparations are
in the Eject Position.
4. Turn the LDG Belt in the appropriate direction
shown in Fig. M1 until the Moving guide prepara-
tions come to the Eject Position. Stop turningPush the tape
when the preparations begin clicking or can not beto load it.
moved further. However, the tape will be left
wound around the cylinder.Push the locking tab gently to unlock
when loading without a cassette.
5. Turn the LDG Belt in the appropriate direction con-
Fig. M1
tinuously, and the cassette tape will be ejected.
Allow a minute or two to complete this task.
Bottom View
LDG Belt (B)
UNLOAD
/EJECT
Cam Gear
Fig. M2
2-3-5T6500MA |
ACEC
PHILIPS
