INSTALLATION
TECHNICAL INFORMATION FOR THE4A) CYLINDER HOLDER COMPARTMENT
INSTALLERThe dimensions of the cylinder compartment have to
Installation, adjustments of controls andpermit the easy loading and unloading of the
maintenance must only be carried out by acylinder.
qualified engineer.For an efficient aeration is necessary to make some
Incorrect installation may cause damage tosmall openings in the furniture, as per fig. 9/A and 9/B.
persons, animals or property for which theThe cylinder holder compartment must have the
Manufacturer shall not be consideredfollowing characteristics:
responsible.- Resistance to a load.
During the life of the system, the automatic- No fitment of the cylinder directly on the floor are
safety or regulating devices on the applianceallowed.
may only be modified by the manufacturer or by- The cylinder equipped with governor must be set
his duly authorized dealer. or take off from the compartment in a easy way.
4) INSTALLING THE HOT PLATE- The cylinder cock must be easily accessible.
Check that the appliance is in a good condition after- The flexible tube musn't be in contact with sharp
having removed the outer packaging and internaledges.
wrappings from around the various loose parts. In- The cylinder holder compartment and the different
case of doubt, do not use the appliance and contactparts of the unit, where the burners are fit, musn't
qualified personnel.be in touch inside.
Never leave the packaging materials (cardboard,- The aeration openings musn't be occluded when
bags, polystyrene foam, nails, etc.) withinthe unit is installed.
childrenOs reach since they could becomeThe appliance belongs to class 3 and is
potential sources of danger.therefore subject to all the provisions
The measurements of the opening made in the topestablished by the provisions governing such
of the modular cabinet and into which the hot plateappliances.
will be installed are indicated in either fig. 9. Always
comply with the measurements given for the hole
into which the appliance will be recessed (seeCOMPLY WITH THE DIMENSIONS
fig.10).
ABCDE
4F553 473 65 62 65 min.
FIG. 9FIG. 9/A FIG. 9/AB FIG. 10
8 |
ACEC
AEG
