START AND STOP
Start and stopStart
Grip the front handle with your
WARNING!left hand and hold the saw
down by putting your right foot
!in the rear handle. Pull the
Y Never start a chain saw unless the bar, chain and allstarter handle with your right
covers are fitted correctly. Otherwise the clutch canhand and pull out the starter
come loose and cause personal injuries.cord slowly until the starter
Y Always move the saw away from the fueling areapawls engage. Then pull
before starting.sharply. Never twist the
Y Place the saw on clear ground and make sure that thestarter cord around your
chain is not contacting anything. Also, make sure thathand.
you have a secure footing.
Y Keep people and animals well away from the workingAs the chain brake is still
area.engaged the speed of the
engine must be set to idling as
soon as possible, this is
achieved by quickly
Cold engine
disengaging the throttle lock.
STARTING:
This prevents unnecessary
The chain brake must be
wear to the clutch, clutch
engaged when the chain saw
drum and brake band.
is started. Activate the brake
by moving the front hand
Push in the choke control
guard forwards.
immediately when the engine
ignites and make repeated
starting attemps. When the
IGNITION:
engine starts, rapidly give full
Move the ignition switch to
throttle. Then the throttle latch
startposition.
will disengage.
CCAUTION! Do not release the
CHOKE:
starter handle from fully pulled
Pull out the choke knob.
out position as this can cause
Adamage on the saw.
FAST IDLE:
1.Push down the throttle
trigger lockout (A).
2.Open the throttle fully (B).
Reactivate the chain brake by
3.Push the throttle latchB
pushing the front hand guard
downwards (C).
back towards the front handle.
The chain saw is now ready
for use.
Stop
Warm engine
The engine is stopped by
Use the same startingswitching off the ignition.
procedure as for a cold(Move the ignition switch to
engine, but do not pull out thestopposition.)
choke knob.
28 � English |
ACEC
HUSQVARNA
