ITEMADJUSTMENT PROCEDURE
E-W PARABOLA1. Call up the adjustment mode display, then select the item DPC .
(DPC)2. Press the TV/VIDEO button on Remote until the cross-hatch pattern appears on
the screen.
3. Press the VOLUME s or t button to make vertical lines straight as shown below.
GENERAL ADJUSTMENTS
HORIZONTAL POSITION1. Call up the adjustment mode display, then select the item HPOS or VPOS .
(HPOS)2. Press the TV/VIDEO button on Remote until the white
VERTICAL POSITIONcross-bar or black cross-bar pattern appears on the
(VPOS)screen.
3. Adjust the HORIZONTAL and VERTICAL position al-
ternately by pressing the VOLUME s or t button for
proper picture position.
4. Check the picture with off-air signal.
HEIGHT1. Call up the adjustment mode display, then select the item HIT.
(HIT)2. Press the VOLUME s or t button to get the picture so the top of raster begins to
lack.
3. Press the VOLUME s button to advance the data by 8 steps.
Note : Check the vertical picture position is correct.
SPECIFIC INFORMATIONSWHITE BALANCE1. Adjust the CONTRAST control to the center, and BRIGHTNESS control to the
(RCUT)maximum.
(GCUT)2. Call up the adjustment mode display, and press the TV/VIDEO button on Remote
(BCUT)until the white and black pattern appears on the screen.
(GDRV)3. Adjust the following item with the CHANNEL s/t and VOLUME s/t buttons.
(BDRV)RCUT Data : 40H GDRV Data : 40H
GCUT Data : 40H BDRV Data : 40H
BCUT Data : 40H
4. Press the TV/VIDEO button on TV to display a single horizontal line on the screen.
5. Turn the SCREEN control (FBT) fully counterclockwise and gradually rotate clock-
wise until the first horizontal line appears slightly on the screen.
6. Press the TV/VIDEO button to display the normal picture.
7. Adjust the remaining two O?CUT� items (CHANNEL s/t ? TV/VIDEO ?
VOLUME s/t in order) tobtain the slightly lighted horizontal line in the sameo
levels of three (red, green, blue) colors. The line should be white if the adjust-
ments are proper.
Bright area
Adjust "GDRV" or "BDRV" to be white.
Dark area
Fine adjust "RCUT", "GCUT" or "BCUT" to be black.
� 13 � |
ACEC
TOSHIBA
