27L-S500,27L-X2000
CL27S50,CL27X200
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:WAVEFORM MEASUREMENT CONDITIONS:
H
1. The unit of resistance "ohm" is omitted.1. Photographs taken on a standard gated color bar
(K=kW =1000W , M=MW )signal, the tint setting adjusted for proper color. The
2. All capacitors are ? F, unless otherwise noted.wave shapes at the red, green and blue cathodes of
(P=pF=??F)the picture tube depend on the tint, color level and
3. (G) indicates ?2% tolerance may be used.picture control.
4. indicates line isolated ground.2. indicates waveform check points (See chart,
5. indicates hot ground.waveforms are measured from point indicated to
Gchassis ground.)
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected�AND SHADED ( ) COMPONENTS
between points indicated and chassis ground, line= SAFETY RELATED PARTS.
voltage set at 120V AC and all controls set for normal'MARK= X-RAY RELATED PARTS.
picture unless otherwise indicated.
2. All voltages measured with 1000? V B & W or ColorDRGANNES MARQUES � ET HACHRES ( ):
Fsignal.PIECES RELATIVES A LA SECURITE.
MARQUE ' : PIECS RELATIVE AUX RAYONS X.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
E
WAVEFORMS
D
C
B
A
12345671890
24 |
ACEC
SHARP
