Loading
WASHER USE
Loading suggestions
For these suggested full-sized loads, set the LOAD SIZE selector
to the highest setting.
Understanding Washer Cycles
SUPER CAPACITY PLUS WASHERS
When the Cycle Control knob is set to a number and pulled out,
the washer fills (to the selected load size) before agitation and
Heavy Work Clothes
timing start. The washer begins agitating immediately after filling;
3 pair pants1 coverall
agitation occurs with the washer lid up or down.
3 shirts1 overall
During agitation, the agitator creates a continuous rollover action 4 pair jeans
that provides a thorough cleaning of the wash load.
Delicates
3 camisoles2 bras
1 quilted robe2 nighties
4 slips1 baby?s dress
4 panties
Towels
10 bath towels
After agitation starts, the Cycle Control knob turns clockwise until 14 wash cloths
10 hand towels1 bath mat
it points to an Off area and the cycle ends.
NOTE: The washer pauses briefly throughout each cycle. These
Mixed Load
pauses are normal for washer operation.
3 double sheets2 shirts
4 pillowcases2 blouses
WASHRINSE
8 T-shirts8 handkerchiefs
6 pair shorts
1. Fill1. Fill
Normal Washer Sounds
Your new washer may make sounds your old one didn?t. Because
2. Wash2. Rinsethe sounds might be unfamiliar, you may be concerned about
selectedthem. These sounds are normal.
time
During washing
When you select a small load size setting, your washer has a
lower water level. This can cause a clicking sound from the upper
?
3. Drain3. Drain
part of the agitator.
No agitation No agitation
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
4. Spin4. Spin-Spray
rinseAfter drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
5. Spin
?
The Casual/Permanent Press 6. Off
cycle partially drains, fills,
agitates briefly, and drains.
5 |
ACEC
WHIRLPOOL
