Load is tangled or twisted
ASSISTANCE OR SERVICE
Did you overload the washer?
The wash load must be balanced and not overloaded. Loads
If you need assistance or service, please check
should move freely during washing.
?Troubleshooting.? If you still need help, follow the instructions
Did you wrap items around the agitator?below.
Drop items loosely into the washer. Do not wrap items around
the agitator.If you need replacement parts
If you need to order replacement parts, we recommend that you
Gray whites, dingy colorsonly use factory specified parts. These parts will fit right and work
right because they are made with the same precision used to
?
Did you properly sort the load?build every new WHIRLPOOL appliance. To locate factory
Dye transfer can occur when mixing whites and colors in a specified parts in your area, call the dealer from whom you
load. Sort dark clothes from whites and lights.purchased the washer or a Whirlpool designated service
company.
Was the wash temperature too low?
NOTE: If the power supply cord of this washer is damaged, it
Use hot or warm washes if safe for the load. Make sure your
must be replaced by a special cord available from the dealer from
hot water system is adequate to provide a hot water wash.
whom you purchased the washer or a Whirlpool designated
Did you use enough detergent, or do you have hard service company.
water?
Use more detergent for washing heavy soils in cold or hard For warranty information
water.Contact the dealer from whom you purchased your washer.
Are the hot and cold water hoses reversed?
Check to be sure the hot and cold water hoses are connected
to the right faucets. See the Installation Instructions.
Wash/Rinse temperature not what I selected
Are the hot and cold water inlet hoses reversed?
See the Installation Instructions for more information. As your
frequency of loads washed increases, the water temperature
may decrease for hot and warm temperatures. This is normal.
Garment damage
Check the following:
Were sharp items removed from pockets before washing?
Empty pockets, zip zippers, and snap or hook fasteners
before washing.
Were strings and sashes tied to prevent tangling?
Were items damaged before washing? Mend rips and broken
threads in seams before washing.
Did you overload the washer?
The wash load must be balanced and not overloaded. Loads
should move freely during washing.
Did you properly add chlorine bleach?
Do not pour chlorine bleach directly on load. Wipe up bleach
spills. Undiluted bleach will damage fabrics.
Did you follow the manufacturer?s care label instructions?
11 |
ACEC
WHIRLPOOL
