ASSEMBLY
Fitting the hand guard and loop Fitting the cutting head
handle(325HDA55, 323HE3)
(325HDA55,323HE3,325HE3)
It is important that the hedge trimmer is laid on a �at surface
1 Assemble the hand guard and loop handle by screwing when you Ţt the cutting head. Otherwise the cutting head may
not be Ţtted straight.
them together. Take care to align the holes in both parts.
1 Fit the cutting head to the shaft. CAUTION! Make sure the
(325HDA55, 323HE3)drive shaft inside the shaft engages with the recess in the
cutting head.
2 Slide the loop handle and hand guard onto the shaft.
(325HDA55, 323HE3)
3 Slide the spacer into the slot in the loop handle.2 Tighten the lower screw Ţrst, then the upper screw.
4 Fit the nut and screw. Do not overtighten.
Adjusting the harness
(325HE4)
You should always use the harness with the machine to give
maximum control over the machine and reduce the risk of
5 Now make a Ţnal adjustment to give yourself a fatigue in your arms and back.
comfortable working position. Tighten the screw. 1 Put on the harness.
CAUTION! The loop handle and hand guard must not be
Å¢tted behind the arrow marked on the shaft.2 Hook the machine onto the harness support hook.
3 Adjust the length of the harness so that the support hook
is roughly level with your right hip.
Fitting the handle
(323HE3, 325HE3,325HE4)
Fit the handle using two screws.
10 - English |